Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Fire alarm bell 14/2 isolated

User: JJWalecka, Location: New England

Asked on: Saturday, September 28, 2024 at 10:47 am EDT
Answered on: Thursday, March 6, 2025 at 3:05 am EST

Question: If you could look at the image you will see the EMT feeding 120 to the fire alarm panel goes through the trough.My question is the 14/2 that goes out to feed the "bell"....does that also need to be isolated from all the fire alarm cables in the trough. Thanks

You're right to be thinking about this! Here's the breakdown based on the NEC (National Electrical Code) and typical fire alarm practices

The short answer: Yes, ideally, it should be isolated, but the NEC doesn't explicitly mandate it in this scenario as strictly as it does for other circuits.

Here's a more detailed explanation


NEC 760.136 (Fire Alarm Circuit Wiring Methods)

This section of the NEC provides guidance, but it is not as prescriptive as Article 725 and 727 concerning separation of other circuits and fire alarm circuits in the same raceway or enclosure.2.

Why Isolation is Generally Good Practice



Preventing Interference

While fire alarm circuits are
supervised (meaning the panel monitors for faults), they're still sensitive. Having line voltage running close by could create electrical noise or interference.

Minimizing Fault Potential

If the 120V wiring were to develop a fault (short to ground), it could potentially interfere with the fire alarm system's ability to function correctly. While the fire alarm system is designed to be fault-tolerant, added risks are not desired.

Simplifying Troubleshooting

Isolating the circuits makes it much easier to troubleshoot problems later on. If there's a fault, you know where to start looking.


Clarity

Clear and distinct wiring practices help prevent future confusion and mistakes during maintenance or modifications.3.

How to Achieve Isolation



Separate Raceways

The best practice is to run the 120V circuit in its own conduit
completely separate from the fire alarm wiring.

Physical Barrier within the Trough

If you must use the same trough, use a physical barrier (divider) inside the trough to create two completely separate compartments. The divider should be metal or a listed non-metallic material suitable for electrical enclosures.

Grouping and Securing

If no barrier, keep the line voltage wiring grouped and secured to one side of the trough, as far away from the fire alarm wiring as possible.

Important Considerations



Local Codes and AHJ (Authority Having Jurisdiction)

Always check with your local electrical codes and the AHJ. They may have stricter requirements than the NEC.

Fire Alarm System Manufacturer's Instructions

The fire alarm panel manufacturer's instructions
may specify wiring requirements beyond the NEC. Follow those instructions.

Professional Judgment

An experienced electrician or fire alarm technician will be able to assess the specific situation and make a judgment based on best practices and local requirements.

In conclusion:


While NEC 760.136 provides guidance, isolating the 120V circuit feeding the "bell" from the fire alarm wiring in the trough is a very good practice. While it's not strictly mandated by the NEC in the same way as other non-power limited circuits, it significantly improves the reliability, maintainability, and safety of the fire alarm system. Use separate raceways or a physical barrier within the trough whenever possible. Always consult local codes, the AHJ, and the fire alarm system manufacturer's instructions. Flag for review

Previous Question Next Question