Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Old mill house meter base

User: Wes0621, Location: South Carolina

Asked on: Tuesday, October 1, 2024 at 11:24 am EDT
Answered on: Thursday, March 6, 2025 at 3:14 am EST

Question: So if the service is attached to an old brick mill house just under the roof overhang. The storm pull it away. Am I ok code to just refasten it back to the home

Generally speaking, yes, you should be okay to re-fasten it back to the house, BUT there are important considerations and caveats



1. Safety First: Call a Qualified Electrician!
Do NOT attempt this yourself if you're not comfortable working with electricity. Electricity is dangerous, and mistakes can be fatal. This is the most important point. Even if you're experienced, this situation requires careful inspection.2. Inspection is Crucial Before Re-Attachment



Wire Condition

The wires themselves may be damaged. Check for cuts, abrasions, broken insulation, or signs of overheating. If the wires are damaged, they MUST be replaced. A qualified electrician can properly inspect and replace the service entrance cable.


Service Head (Weatherhead)

Inspect the weatherhead (the fitting where the wires enter the conduit) for damage. If it's cracked or broken, water can get into the electrical system, which is dangerous.

Conduit/Mast

Check the conduit (the pipe containing the wires) for any bends, kinks, or breaks. If the conduit is damaged, it needs repair or replacement.


Attachment Point Integrity

Inspect the brick where the service was originally attached. Is the brick cracked or loose? If so, simply reattaching could cause further damage and create a safety hazard. You may need to reinforce the brick or use a different attachment method.

Grounding

Verify that the grounding is still intact and properly connected. Grounding is essential for safety.


Meter

The meter itself may have been damaged in the pull-away. Visually inspect it and contact your utility company if you suspect any problems.

3. Code Considerations (General)



Clearances

The service drop (the wires coming from the pole) must have proper clearance from the ground, windows, doors, and other structures. Reattaching it in the same location
should maintain those clearances, but double-check. Local codes will specify these clearances.

Secure Attachment

The service mast (if applicable) and service entrance cable must be securely attached to the building. Use appropriate hardware and fasteners designed for this purpose. The hardware should be rated for outdoor use and resistant to corrosion. Make sure you are using the correct type of fasteners that are rated for the weight that is being supported.

Weatherproof

All connections must be weatherproofed to prevent water from entering the electrical system.


Proper Wiring Methods

Ensure that the wiring is done according to code (e.g., proper wire gauge, type of conduit).

4. Notify the Utility Company



Even if you're confident in your repair, it's a good idea to notify your utility company.
They may want to inspect the connection point before re-energizing the service. They are responsible for the service drop up to the point of attachment to your house. Do NOT try to reconnect the service drop wires yourself! This is extremely dangerous and must be done by the utility company.5. Permits

* Check with your local building department to see if a permit is required for this type of repair.

In summary


Call a licensed electrician.
2. Have the electrician thoroughly inspect the entire service entrance (wires, conduit, weatherhead, attachment point, meter, grounding).
3. Ensure that all repairs are done according to local electrical codes and using appropriate materials.4. Notify the utility company.
5. Obtain any necessary permits.Ignoring these steps can create a serious safety hazard, potentially leading to fire, electrocution, or damage to your electrical system. Don't take the risk. Get professional help. Flag for review

Previous Question Next Question