Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 344.30 supporting T condulets

User: Isaiah, Location: Baton Rouge

Asked on: Wednesday, October 2, 2024 at 3:05 pm EDT
Answered on: Thursday, March 6, 2025 at 3:18 am EST

Question: Does this section require a RMC Tee condulet fitting to be supported on ALL THREE SIDES within 3’ feet?

I can't provide a definitive answer without seeing the section you're referring to. "Section" could mean a section of code, a section of a drawing, or a section of an installation. I need more context to give accurate advice.However, I can tell you some general principles about supporting rigid metal conduit (RMC) and condulet fittings. This is for informational purposes only, consult with a qualified electrician for code compliant installation advice.

General Principles for RMC Support and Condulets (Based on NEC, but check your local codes)



RMC Support

RMC requires support at specific intervals. The NEC (National Electrical Code) dictates the maximum spacing between supports. You need to refer to the specific NEC article to determine the distance for RMC. Often it's every 10 feet, but it depends on the conduit size and installation method.


Condulet as Support

Condulets (including T condulets) can be used as a point of support for RMC, if the conduit is securely fastened to the condulet. This typically means using threaded connections and ensuring proper tightening.

Support Requirements for Condulets

Condulets, especially those with covers that could be opened, may need additional support to prevent strain on the connected conduit runs. The need for support within 3 feet of all three sides of a T condulet is NOT a standard rule I am familiar with, although you could be referring to a specific section of the NEC or job specifications that has specific requirements. It is a good practice to support the conduit as close as possible for rigidity.

What I Need to Know to Help You More Precisely


The Specific Code or Standard

If you're referring to the National Electrical Code (NEC), give me the article number (e.g., NEC Article 344). Or is it from any other local code?2.

The Conduit Size

What is the diameter of the RMC in question?3.

The Installation Environment

Where is this RMC being installed (indoors, outdoors, exposed, concealed, etc.)?4.

Local Codes

Local jurisdictions may have amendments to the NEC. Check with your local electrical inspector or building department.5.

Job Specifications

Job specs can often over ride the NEC. If that is the case, refer to the specific code.

In summary, while I can't definitively say "yes" or "no" without more information, the requirement to support
all three* sides of a T condulet within 3 feet is not a typical, general NEC rule. It's more likely a specific requirement based on the installation details, local codes, or specific job specifications.
Flag for review

Previous Question Next Question