User: Jerzeysfinest, Location: New jersey
Asked on: Thursday, October 3, 2024 at 6:51 pm EDT
Answered on: Thursday, March 6, 2025 at 3:24 am EST
Question: so there is a disconnect outside under the meter can that has a 200 amp breaker inside , that feeds the power to the home on the property that will be delivered soon now my question is if the new home has a main panel that is 100 amps what would you run that as ? service wise and what size wire ? see i would assume they should take the 200 amp breaker out the disconnect and install a 100 amp and then run the service as a 100 amps ! or is there another option here as i do know the new panel will accept the wire size of a 200 amp service > please any help on what the best thing to do is please . i always like to triple check things especially in new areas >
Okay, let's break down the situation and the best approach for your service connection. You're right to be cautious and double-check.
Understanding the Situation
Existing
200A breaker in an outside disconnect feeding the property. This is your service disconnect.
New Home
Has a 100A main panel.
Question
How to properly connect the 200A feed to the 100A panel, and what size wire is appropriate.
The Correct Approach
The most important thing is to protect the wiring and the 100A panel. Here's the recommended course of action and why:1. You are absolutely correct: Reduce the breaker size. The 200A breaker in the disconnect must be reduced to match the load that is being ran. It is the size of the load that calls the wire size . (So whatever your load is on your 100amp panel that's what your wire size must be able to handle).2. Wire Size
The wire to the 100A Panel
MUST be rated to carry 100 amps.
Why this is important
Overcurrent Protection
The breaker's purpose is to protect the wires from overheating and causing a fire. If you have a 200A breaker feeding a 100A panel, and a fault occurs that draws (for example) 150A, the 200A breaker won't trip. The wiring feeding the 100A panel will be overloaded, potentially causing it to overheat and start a fire.
Code Compliance
Electrical codes are very specific about overcurrent protection. You MUST protect the wiring according to its ampacity (current-carrying capacity).
Steps to Take
Consult an Electrician
It is imperative to consult a qualified electrician. This situation requires an expert eye. They can assess the actual load, confirm code requirements, and perform the work safely.2.
Verify Load Calculation
Even though the main breaker is 100A, have the electrician perform a load calculation for the new home. This will determine if 100A is truly sufficient. Factors like appliances, HVAC, square footage, etc., all contribute to the load. It's possible you might need a larger service in the future.3.
Permits and Inspections
Ensure all work is done with the appropriate permits and inspections. This is essential for safety and to ensure compliance with local codes.4.
Documentation
Keep records of all work done, including permits, inspections, and any documentation from the electrician.
In Summary
Do NOT leave the 200A breaker in place. It's a safety hazard. Reduce the breaker size to 100A. Use wire rated to 100A. Consult a qualified electrician for the work and permitting. They can also help determine if 100A is truly sufficient for the new home's needs.
Important Safety Note: Electrical work can be dangerous. If you are not a qualified electrician, do NOT attempt to perform this work yourself. Always hire a licensed professional. Flag for review