Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Condominium water bond.

User: Tdubya90, Location: Denver

Asked on: Wednesday, October 9, 2024 at 4:38 pm EDT
Answered on: Thursday, March 6, 2025 at 3:42 am EST

Question: Hi, kinda dumb question but, if you're doing a sub panel swap on a condominium unit, does the water pipe need to be bonded to the sub panel?

That's not a dumb question at all! It's important to get this right.The answer is yes, typically the water pipe needs to be bonded to the subpanel in a condominium unit, just like in a house.

Here's why, based on the National Electrical Code (NEC) and general electrical safety principles: Purpose of Bonding

The purpose of bonding metal water piping (and other metal components like gas piping) to the electrical system is to create a low-impedance path back to the source of the electrical supply. This path is
critical for safety in the event of a fault (e.g., a hot wire accidentally touching the metal pipe). If a fault occurs, the bonding ensures that a large amount of current flows through the grounding/bonding system, quickly tripping the circuit breaker or blowing the fuse protecting that circuit. This prevents the metal pipe from becoming energized at a dangerous voltage, which could cause electric shock if someone touched it.

NEC Requirements (General)

The NEC generally requires bonding of interior metal water piping systems to the electrical grounding system. This is usually done at the service entrance (main panel). But, because of "separately derived systems", sub panels that are fed from other panels are also considered to be individual systems.

Subpanels

Subpanels are required to have a grounding electrode conductor ran with the feeder wires back to the main panel. The grounding electrode conductor and the neutral conductor must be kept seperate at the subpanel, there is generally no point where they can touch. Subpanels are required to have their own grounding bus which all grounding conductors are connected to.


Condominiums

The fact that it's a condominium unit doesn't automatically exempt it from bonding requirements. The same principles of electrical safety apply.

Important Considerations and Caveats



Local Codes and Inspections

Always consult your local electrical codes and regulations, as they may have specific requirements or interpretations that go beyond the NEC. And of course, always consult with a qualified electrician.


Existing Bonding

Check to see if the water pipe is already bonded to the main panel or to another grounding point within the building's electrical system. This is a common practice, especially in older buildings. If it is, you will still want to bond it to your new subpanel so that there are two bonded locations along the piping system.

Type of Pipe

If the water pipes are
entirely non-metallic (e.g., PVC or PEX) throughout the unit and throughout the building, then the bonding requirement for the water pipe might not apply. However, this is relatively rare, as there are almost always some metal components in the water system (e.g., at the water heater, fixtures, or valves).

Approved Methods

Use approved methods and materials for bonding, such as listed bonding clamps and appropriately sized copper bonding conductors. Consult the NEC for specific sizing requirements.

In summary: Assume you need to bond the water pipe to the subpanel unless you have concrete evidence that it's not required (e.g., entirely non-metallic plumbing) and you've confirmed this with your local electrical inspector or a qualified electrician.


When in doubt, it's always best to err on the side of caution and bond the water pipe. It's a small effort that can significantly improve electrical safety.

Disclaimer: I am an AI chatbot and cannot provide professional electrical advice. This information is for general educational purposes only. Always consult with a qualified and licensed electrician for any electrical work. Flag for review

Previous Question Next Question