Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: EMT coupling

User: perturbed, Location: Bethlehem PA

Asked on: Monday, October 14, 2024 at 4:53 pm EDT
Answered on: Thursday, March 6, 2025 at 3:54 am EST

Question: the house I'm in was renovated in 2018 before i bought it. There's a short vertical piece of EMT mounted to a block wall that ends in a switch box. There's a combination coupling at the top of the EMT, which leaves about 2 inches of romex exposed between the coupling and drywall ceiling. I'm assuming the EMT is to protect the romex. Shouldn't the EMT have gone all the way through the ceiling or does the coupling have to be visible?

You're right to be concerned about the exposed Romex. Here's a breakdown of the situation and what's likely the problem

Understanding the Issue
Purpose of EMT

Electrical Metallic Tubing (EMT, or "thinwall conduit") is typically used to protect Romex (NM-B cable) from physical damage, especially where it's exposed and vulnerable.


Exposed Romex is a Potential Problem

Romex is not designed for exposure. It can be easily damaged by abrasion, impacts, or pests. Direct exposure goes against safety protocols.

Coupling Concerns

While couplings are necessary for joining EMT sections, the current setup with 2 inches of exposed Romex negates the protection the EMT is supposed to provide.

Possible Reasons and Violations
1. Improper Installation/Shortcut

The most likely explanation is simply that the renovator took a shortcut. They might have:
Used a pre-cut length of EMT that was too short. Found it easier to stop the EMT short of the ceiling.2.

Lack of Proper Support/Fastening

EMT must be properly supported and fastened according to code.3.

Violation of NEC (National Electrical Code)

Several sections of the NEC could be relevant here, depending on the specifics:


NEC 300.4(F) Protection Against Physical Damage

This covers general requirements for protecting cables where they pass through framing members.

NEC 320 (Article on NM-B Cable)

This article specifies where and how Romex can be used.


NEC 314 (Outlet, Device, Pull, and Junction Boxes)

This covers requirements for using boxes and fittings, and how they are to be supported.

Solutions and Recommendations
1. Extend the EMT

The ideal solution is to extend the EMT to a proper fitting (such as a connector that is designed to transition from EMT to NM cable) inside the switch box in the ceiling. This would completely enclose the Romex and provide proper protection. This likely involves: Turning off the breaker to the circuit. Removing the switch/device in the box below. Removing the existing combination coupling. Adding a length of EMT and a proper connector (likely a box connector) to go into the switch box in the ceiling. Reconnecting everything.2.

Use a Different Type of Fitting

If extending the EMT all the way isn't feasible (due to space constraints, difficulty fishing the Romex, etc.),
another acceptable solution might be to use a different type of fitting that provides better strain relief and protection at the transition. However, this is less desirable than extending the EMT and using a proper connector inside the box above.
Important Safety Considerations
Electricity is Dangerous

Always turn off the power at the circuit breaker before working on any electrical wiring.

Call a Qualified Electrician

Unless you're very comfortable and knowledgeable about electrical work,
hire a licensed electrician to evaluate the situation and make the necessary repairs. They will know the local codes and can ensure the work is done safely and correctly.

Don't DIY if Unsure

Improper electrical work can be a fire hazard and could lead to serious injury or death.

In summary, the exposed Romex is a problem. The EMT should ideally extend into a box above the ceiling to fully protect the cable. Contact a qualified electrician to properly assess the situation and make the necessary repairs.
Flag for review

Previous Question Next Question