Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: NEC Table 240.6 A. The adding of 10Amps

User: elmundogrande, Location: Northern illinois

Asked on: Wednesday, October 16, 2024 at 4:43 pm EDT
Answered on: Thursday, March 6, 2025 at 4:01 am EST

Question: Question I just noticed that they add 10amps to standard breaker or fuse table 240.6A just wondering do they make a 10a fuse or inverse time breaker

You're right to be curious about the apparent discrepancy between Table 240.6(A) and typical fuse/breaker ratings. Here's the breakdown: Table 240.6(A): Standard Ampere Ratings for Overcurrent Protective Devices

This table
is a standard listing of available breaker and fuse sizes. While it doesn't explicitly list a 10 amp breaker or fuse, it is more of a 'rule of thumb' table.

10 Amp Fuses and Breakers DO Exist

YES, 10 amp fuses and breakers are manufactured and used. They are not "standard" in the sense of being readily available at a big box home improvement store, but they are common in specific applications like:

Electronics

Equipment often has internal fusing at lower amperages, including 10A.


Control Circuits

Industrial control panels and similar systems may use 10A fuses or breakers for control power or specific components.

Specific Appliances

Some appliances are rated to use only 10 amps, especially appliances manufactured to meet European or other international standards.


Availability

You are correct, that 10 amp breakers and fuses are not easily available at the local hardware or big box store. You will have to go to a supply house, or order them online from industrial/electronics supply distributors.

So, why the confusion?
Typical Residential/Commercial Applications

In typical residential and commercial wiring (North America), the loads often require larger conductors and, consequently, larger overcurrent protection (15A and up). Therefore, the demand for 10A breakers in those settings is lower.


Minimum Branch Circuit Rating

NEC Article 210.21(B)(1) says that an overcurrent device shall not be loaded to exceed 80% of its rating. This is why we can load a 15 amp circuit to 12 amps of continuous load. 210.21(B)(1) is referring to branch circuit loads.

Inverse Time Breakers


You also asked about "inverse time breakers." All standard thermal-magnetic circuit breakers are inherently inverse time. "Inverse time" means that the time it takes for the breaker to trip is inversely proportional to the amount of current flowing through it. High Overload (Short Circuit)

If a very high current flows (e.g., a short circuit), the breaker trips almost instantly.


Lower Overload (e.g., 120% of Rating)

If a smaller overload occurs, the breaker will take longer to trip (minutes or even hours). This delay allows for temporary inrush currents (like when a motor starts) without tripping the breaker unnecessarily.

In summary

10 Amp fuses and breakers do exist and are used in specific applications. Table 240.6(A) lists common sizes but is not exhaustive. Typical residential and commercial wiring rarely necessitates 10A protection. All standard thermal-magnetic breakers are inverse time.If you are designing or working on a system where you need 10A protection, you will need to source those devices from a specialized supplier (electrical supply house or online distributor specializing in electrical or electronic components).

Disclaimer:
I am an AI chatbot and cannot provide professional electrical advice. Consult with a licensed electrician for any electrical work. Always follow applicable codes and regulations. Flag for review

Previous Question Next Question