Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Is this the correct breaker

User: JJWalecka, Location: New England

Asked on: Thursday, October 17, 2024 at 10:41 am EDT
Answered on: Thursday, March 6, 2025 at 4:03 am EST

Question: I have a 125 amp eaton breaker to be changed to a 60 amp eaton breakerSee imagesWhat numbers on the two images should I be comparing to see if the 60 amp is the same as the 125 amp

Okay, let's break down what you should be looking for to ensure the 60A breaker is compatible with your panel. We'll focus on the key things to check for physical and electrical compatibility.

Here's what you need to compare between the two breakers



Frame Size/Series

This is the
most important factor for physical fit. You need to make sure the 60A breaker is the same series as the existing 125A breaker. Look for numbers like these

BR
Type BR Voltage Rating

Make sure the voltage rating of the 60A breaker is equal to or greater than the voltage of your electrical panel. Your panel is most likely 120/240V. The breaker must be rated for at least that.

AIC Rating (Interrupting Capacity)

This is a crucial safety factor. The AIC rating indicates the breaker's ability to safely interrupt a fault current (short circuit). The AIC rating of the 60A breaker must be equal to or
greater than the minimum AIC rating specified for your panel. The AIC rating is typically expressed in thousands of amperes (kA). Common ratings are 10kA.

Important Safety Notes



Work should be done by a qualified electrician

Electrical work can be dangerous. If you are not a qualified electrician,
do not attempt this yourself. Hire a licensed electrician to perform the breaker replacement.

Turn off power

Before doing any work, turn off the main breaker to the panel to cut off all power.*

Verify dead:
Use a non-contact voltage tester to verify that the breaker and its associated wires are de-energized before touching anything.Essentially, you're primarily looking for the "BR" or "Type BR" marking to match, confirming it's the correct physical type for your panel. Then, verify the voltage and AIC ratings are suitable. Don't proceed if anything is unclear or doesn't match. Flag for review

Previous Question Next Question