Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: LED 6W bulb modification

User: junkhound, Location: Renton, WA

Asked on: Thursday, October 17, 2024 at 11:04 am EDT
Answered on: Thursday, March 6, 2025 at 4:03 am EST

Question: If I am installing a LED bulb in a fixture that only has downward or outward lighting direction I always bandsaw off the plastic bulb and put a dab of RTV over the exposed terminals if any..I get a lot more light from the same lamp.Is there anything in NEC that prohibits this?

Okay, let's break this down. What you're describing is a modification of a Listed (and presumably rated) electrical product. Here's why that's problematic from an NEC and safety perspective

NEC Concerns and Prohibitions:
110.3(B) Installation and Use

"Listed or labeled equipment shall be installed and used in accordance with any instructions included in the listing or labeling." When you cut off the plastic housing of an LED bulb, you're fundamentally altering the equipment and violating its original listing. The listing is issued by a Nationally Recognized Testing Laboratory (NRTL) such as UL, ETL, CSA, etc., and it signifies that the product has been tested and found to meet certain safety standards.


110.3(A)(1) Examination

"Electrical equipment shall be free from hazards and shall be judged to be acceptable only if...it is acceptable only if installed in accordance with any instructions included in the listing or labeling."

410.6 Alterations to Lamps

While it doesn't specifically address LEDs, this section implies the general principle: "Lamps shall not be altered or modified to defeat their intended purpose or create a hazard." Your modification could be argued to create a hazard.

Safety Hazards


Electrical Shock

Exposing internal components, even with RTV, increases the risk of accidental contact and electrical shock. RTV is not a substitute for the insulation provided by the original bulb housing.2.

Fire Hazard

LED bulbs, while more efficient than incandescent, still generate heat. The plastic housing is often designed to help dissipate that heat. Removing the housing can cause the components to overheat, potentially leading to a fire.3.

Compromised Insulation

The plastic housing provides insulation and protection against environmental factors (dust, moisture, etc.). Removing it exposes the internal components to these factors, which can degrade the insulation and create a safety hazard.4.

Voiding of Warranty/Liability

Modifying the bulb voids the manufacturer's warranty. More importantly, if your modification causes a fire or injury, you could be held liable.

Why the Housing is There

The plastic housing of an LED bulb isn't just for aesthetics. It serves several critical functions:


Electrical Insulation

Prevents accidental contact with live parts.

Heat Dissipation

Helps to cool the LED components and prolong their lifespan.


Physical Protection

Protects the internal components from damage.*

Light Diffusion/Direction

In some designs, the housing helps to diffuse or direct the light.

Better Alternatives

If you want more light from a fixture, consider these safer and code-compliant options:1.

Use a higher wattage/lumen bulb

Check the fixture's maximum wattage rating and use the highest wattage LED bulb that is rated for the fixture and provides the desired light output (lumens). LEDs have much lower wattage consumption than incandescent bulbs for the same light output.2.

Use a bulb with a wider beam angle

Some LED bulbs have a wider beam angle, which will distribute the light more evenly.3.

Replace the fixture

If the fixture is inadequate, consider replacing it with a fixture that provides the desired light output and direction.4.

Reflector bulb

Some reflector bulbs will concentrate the light, and you could try one of these.

In Conclusion:


Modifying electrical equipment in the way you describe is a violation of the NEC and creates significant safety hazards. It's simply not worth the risk. Stick to using Listed equipment as intended and explore safer alternatives for increasing the light output of your fixtures. Flag for review

Previous Question Next Question