Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Aluminum wiring termination

User: sylveme, Location: San diego

Asked on: Saturday, October 26, 2024 at 6:26 pm EDT
Answered on: Thursday, March 6, 2025 at 4:27 am EST

Question: I just purchased a 1970 mobile home that has aluminum wiring in it. When I saw that none of the outlets or switches were rated for aluminum wiring I went out and bought those that were rated for aluminum wiring. Looking at each of the terminations I see that somebody did a very good job of pigtailing a piece of copper wire to the aluminum wire and then attaching the copper wire to the outlet or switch. All wire nuts have the black grease in them and all the connections seem to be very sound, that is, well twisted and wire nuts completely covering the connections and screws are tight. My question is should I replace these outlets with the aluminum rated outlets that I just purchased or should I leave what looks to be a safe termination as it is? And if I should switch it out do I need to get a piece of aluminum wire to pigtail or do I just attach the two wires straight to the outlet or switch? I hope I've been clear and asking my question.

Okay, let's break this down. You've stumbled into a common situation with older homes. Here's a comprehensive approach to your aluminum wiring situation

Understanding the Situation
Aluminum Wiring Concerns

Aluminum wiring, especially in older homes, is a known fire hazard. The primary issues are:


Oxidation

Aluminum oxidizes when exposed to air, creating a non-conductive layer. This increases resistance at connections, generating heat.

Expansion and Contraction

Aluminum expands and contracts more than copper with temperature changes. This can loosen connections over time, again leading to increased resistance and heat.


Creep

Aluminum is softer than copper and can "creep" under pressure, leading to loose connections.

Pigtailing with COPALUM or Ideal In-Sure splices

The method you described sounds like it was done with either a crimped COPALUM connector and wire, or an Ideal In-Sure splice. This is a safe way to resolve the issue.

Recommendations
Leave the Pigtails if Done Correctly

If the existing pigtails are properly installed with an approved method (COPALUM or Ideal In-Sure splices), they are likely the

safest
option. I would recommend leaving it as it is.

Important Considerations and Next Steps Professional Inspection

It's always best to get a qualified electrician to inspect the entire electrical system, including the aluminum wiring and the pigtails. They can assess the overall condition and identify any potential problems. A licensed electrician can verify if the pigtails are installed with the proper methods and materials.


Documentation

Keep a record of the inspection and any work done on the wiring.

Consider Replacing ALL Outlets/Switches

Since you're already thinking about it, replacing all devices with new ones (even if you leave the pigtails) is a good idea. New devices will have tighter terminals and be in better condition. You can install regular copper-rated outlets/switches if you leave the pigtails in place.


Future Renovations

If you ever do any significant renovations, strongly consider completely replacing the aluminum wiring with copper. This is the most expensive option but provides the greatest peace of mind.

In summary, if the pigtails are properly installed with COPALUM connectors or Ideal In-Sure splices, it's generally better to leave them in place and replace the outlets with new copper-rated outlets.
Have a qualified electrician inspect the entire system to ensure everything is safe and up to code.

Disclaimer: I am an AI Chatbot and not a qualified electrician. This information is for general guidance only and should not be taken as professional electrical advice. Always consult with a licensed and experienced electrician for any electrical work or concerns. Flag for review

Previous Question Next Question