Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Romex exposed under covered patio

User: Deke1069, Location: SC

Asked on: Wednesday, November 6, 2024 at 2:56 pm EST
Answered on: Thursday, March 6, 2025 at 4:54 am EST

Question: I'm working on making corrections on a residential inspection report for the sale of a home, one of the repairs the home inspector noted was the exposed romex running under a wood patio cover. The romex is running through bored holes not stapled on the bottom of the joists, there isn't any drywall or any other sheeting to cover the romex. Does this need to be installed in a conduit? If it's code compliant what is the code section.Thank you.Joe

Okay, Joe, let's break down the Romex (NM cable) situation under the patio cover and whether it requires conduit.

Key Considerations



Exposure to Physical Damage

This is the BIGGEST determining factor. Is the Romex likely to be damaged by someone bumping into it, weather, animals, or other physical hazards?


Location

While a patio cover provides some protection, it's generally considered a potentially damp or exposed location.

Local Amendments

Keep in mind that local jurisdictions can amend the NEC. Always check with your local building department to verify specific requirements in your area.

Here's the analysis based on the National Electrical Code (NEC)



NEC and NM Cable (Romex) - Direct Quote
334.10 Uses Permitted (3) Other Structures. Types NM, NMC, and NMS cables shall also be permitted to be installed in other structures, such as detached garages or storage buildings. 334.12 Uses Not Permitted (A) Types NM, NMC, and NMS. Types NM, NMC, and NMS cables shall not be used under the following conditions or in the following locations:(1) In commercial garages or motion picture studios and similar locations.(2) In theaters and similar locations, except as provided in Article 518.(3) In hoistways or elevators.(4) In hazardous (classified) locations, except as permitted by Articles 500 through 516.(5) Embedded in poured concrete, cement, or aggregate.(6) Where subject to physical damage.(7) Where exposed to corrosive fumes or vapors.(8) Where exposed to sunlight unless identified for the purpose.

Analysis and Recommendations


Physical Damage

The most critical aspect is whether the exposed Romex under the patio cover is
subject to physical damage as per NEC 334.12(A)(6). If it's easily accessible and vulnerable to being hit, snagged, or otherwise damaged, it

IS NOT
code-compliant as is. If it's high enough where it's not possible to come in contact with it or it's protected somehow, it could be code-compliant.2. Protection Methods



Conduit

The safest and often easiest solution is to run the Romex inside conduit. This provides excellent physical protection. PVC conduit is generally acceptable in this application, but check local codes. Metal conduit (EMT, Rigid) is also an option.

Running Boards/Guards

You
might be able to use running boards or guards to protect the Romex from physical damage. This involves installing a solid piece of wood or metal along the underside of the joists to shield the cable. The effectiveness of this depends on the specific layout and the potential for damage.

Relocation

Consider if the wiring can be rerouted to a less vulnerable location.3.

Securing and Supporting

Even if physical protection isn't the primary issue, the Romex still needs to be properly secured and supported.

334.30 Securing and Supporting.
Nonmetallic-sheathed cable shall be supported and secured by staples, cable ties, straps, hangers, or similar fittings designed and installed so as not to damage the cable, at intervals not exceeding 4 1 ⁄ 2 ft and within 12 in. of every outlet box, junction box, cabinet, or fitting. Flat cables shall not be stapled on edge. The fact that it's running through bored holes is okay for support, as long as those holes meet the fill requirements. This doesn't negate the requirement for securing the cable within 12" of boxes, etc.

My Recommendation for Correction

Based on the information provided, here's the most likely scenario and my recommended course of action:1.

Assume it's NOT compliant
without further protection. The inspector flagged it, which implies they see a potential for damage.2. RECOMMENDATION TO CLIENT

"The exposed Romex cable running under the patio cover is potentially subject to physical damage. To ensure code compliance and prevent future electrical hazards, it is recommended that a qualified electrician install the Romex cable inside conduit (PVC or EMT) or provide adequate physical protection using running boards/guards. All work should be performed in accordance with the National Electrical Code and local building codes."

Important Disclaimers



I am an AI Chatbot and cannot provide definitive code interpretations.
I can provide general guidance, but the final determination rests with the local electrical inspector and the qualified electrician performing the work. Always consult with a licensed electrician. They can assess the specific situation, determine the best course of action, and ensure compliance with all applicable codes.* Check Local Codes! Local amendments to the NEC can significantly impact what's allowed.By taking these steps, you'll help your client address the potential safety issue and ensure the electrical system meets the required standards. Good luck! Flag for review

Previous Question Next Question