Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Flex conduit

User: Alwayslearningelec, Location: NJ

Asked on: Wednesday, November 13, 2024 at 8:31 am EST
Answered on: Thursday, March 6, 2025 at 5:09 am EST

Question: Have customer wanting flex conduit(did not describe type yet) run underground for temporary application. About 500'. It's going to contain fiber cables. Should flex be run underground even if it only has fiber and is temporary? Thanks

Okay, let's break this down. While fiber optic cable itself doesn't carry electricity, the implications of using flexible conduit underground, even temporarily, need careful consideration.

Key Considerations



Code Compliance



NEC 300.5 (Underground Installations)

This section of the National Electrical Code (NEC) is critical. While fiber is low voltage (if any voltage) but conduit selection still needs to follow NEC 300.5.

NEC 300.5(D) (Direct Burial Cables)

If the fiber cable itself is rated for direct burial, you might technically be able to bury it directly (check the cable's jacket rating). However, conduit provides much better protection.


NEC 356 (Liquidtight Flexible Nonmetallic Conduit: LFNC)

This article covers LFNC, and specifically mentions its permitted uses underground. It's a good choice if the application is allowed.

NEC 348 (Flexible Metal Conduit: FMC)

This article covers FMC, and it generally is

not suitable
for direct burial without specific listings. Local Amendments

Always check local codes and ordinances, as they can be stricter than the NEC. The AHJ (Authority Having Jurisdiction) has the final say.

Conduit Type and Protection



Type

Based on the NEC and typical practices,

LFNC (Liquidtight Flexible Nonmetallic Conduit)
is often the most appropriate choice for a temporary underground fiber run. Direct Burial Rating

Verify the specific LFNC you are considering is listed and rated for direct burial. Many are, but it's crucial to check the manufacturer's specifications.


Depth

The burial depth might be dictated by local codes.

Physical Protection

Conduit protects the fiber from damage during and after installation.


Temporary vs. Permanent

Even if it's temporary, safety and code compliance are paramount. The "temporary" nature doesn't excuse you from following best practices.

Potential Hazards



Water Ingress

Even LFNC can leak over time, especially at connections if not properly sealed. Water can damage fiber optic connectors and possibly the fiber itself. Consider using gel-filled or water-blocked fiber cables.

Rodents/Pests

Underground conduits can attract rodents who might chew on the cable.


Mechanical Damage

Digging, settling soil, or other activities can damage unprotected fiber.

Future Considerations



Transition Points

How will the conduit transition from underground to above ground? Proper sealing and protection at these points are essential.

Removal

How easily can the conduit be removed when the temporary application is done? This might influence your choice of burial depth and backfilling methods.

Recommendations


Confirm the "Flex" Type

Ask the customer
exactly what kind of flexible conduit they are referring to. It's likely LFNC, but get clarification.2.

Suggest LFNC

Recommend LFNC that is rated for direct burial.3.

Cable Type

Ensure that the fiber cables are indoor/outdoor and ideally water-blocked cables.4.

Proper Installation

Use appropriate fittings and sealing methods to prevent water ingress. Consider using conduit sealant at connections.5.

Burial Depth

Follow NEC 300.5 (if applicable) and local regulations for burial depth.
6.


Marking

Mark the location of the buried conduit with warning tape or other suitable markers to prevent accidental damage during digging.7.

Documentation

Document the installation, including the type of conduit, burial depth, cable type, and any other relevant information.8.

Consult AHJ

If there's any doubt, consult with the local Authority Having Jurisdiction (AHJ) to get their approval on the proposed installation.

Example Message to Customer

"Regarding the underground fiber run, I recommend using Liquidtight Flexible Nonmetallic Conduit (LFNC) that is rated for direct burial. This provides good protection for the fiber cable. We need to make sure the fiber cable is also indoor/outdoor rated and possibly water-blocked. To give you an accurate quote, can you confirm the specific type of 'flex' you were thinking of, and the exact type and rating of the fiber cables being used. Also, I will need to check local regulations regarding burial depth and any specific requirements for temporary underground installations."

In Summary:


While
technically direct burial of fiber optic cable might be permitted in some cases if the cable is rated for it, it's generally not recommended* for a 500-foot run, even temporarily. The added protection of LFNC is well worth it. Make sure all components are rated for direct burial, installed correctly, and comply with all applicable codes and regulations. Always prioritize safety and long-term reliability. Flag for review

Previous Question Next Question