User: Guero, Location: Duarte2121$
Asked on: Friday, November 22, 2024 at 11:15 pm EST
Answered on: Thursday, March 6, 2025 at 5:35 am EST
Question: Had a question on the test regarding corded plug sump pump allowed in elevator pit.Where can I find more info on this in code book.
Okay, this is a common point of confusion, and it's good you're checking! The key is to understand the specific codes and regulations that apply to elevator pits. The relevant areas are usually electrical codes and elevator codes.
Key Code Sections and Considerations
National Electrical Code (NEC)
While the NEC doesn't specifically say "sump pumps in elevator pits must be hard-wired," it's the application of other NEC articles that effectively leads to that conclusion. Here's the breakdown:
Article 620 - Elevators, Dumbwaiters, Escalators, Moving Walks, Platform Lifts, and Stairway Chairlifts
This is the primary NEC article governing electrical installations in and around elevators. It addresses:
620.11
"Working Clearances." It requires sufficient space around electrical equipment for safe maintenance and operation. This is important in the context of a submerged or partially submerged pump.
620.85(A) and (B) Ground-Fault Circuit Interrupter (GFCI) Protection. This section often requires GFCI protection for 125-volt, single-phase, 15- and 20-ampere receptacles in elevator machine rooms, control rooms, and hoistways. The installation of a cord-and-plug connected device would need to adhere to this and a GFCI would likely be required. Article 400 - Flexible Cords and Cables
400.8(1) - Uses Not Permitted
This section details prohibited uses for flexible cords. It generally prohibits using flexible cords "as a substitute for the fixed wiring of a structure." This is the big one. Installing a cord-and-plug connected sump pump as a permanent solution for water removal in an elevator pit is often considered using it as a substitute for fixed wiring.
400.7(A) - Uses Permitted
This section lists acceptable uses for flexible cords. None of them directly apply to a permanently installed sump pump. Examples include portable appliances, pendants, or temporary wiring.
Article 430 - Motors, Motor Circuits, and Controllers
If the sump pump motor is larger, requirements of Article 430 would apply.
Article 680 - Swimming Pools, Fountains, and Similar Installations
While not directly applicable, it provides guidance on wet locations and grounding requirements, which can be informative.2.
Elevator Codes (ASME A17.1 / CSA B44)
The Safety Code for Elevators and Escalators (ASME A17.1 in the US, CSA B44 in Canada) is crucial. While it does not directly address cord-and-plug connected sump pumps, it implies the need for permanent, reliable, and code-compliant solutions for water removal. Specifically, look for sections that cover:
Pit Requirements
These sections detail the required depth, access, lighting, and drainage of the pit.
Water Accumulation
The code emphasizes preventing water accumulation in the pit, as it can damage equipment and create safety hazards. The code also mentions where the water needs to be discharged to.
Electrical Safety
The elevator code refers to the electrical code (NEC/CEC) for electrical installations within the hoistway and pit.3.
Local Amendments and AHJ (Authority Having Jurisdiction)
This is extremely important. Local jurisdictions can amend the NEC and elevator codes. They may have specific regulations about sump pumps in elevator pits.
Always check with your local building department or electrical inspector. Their interpretation is what ultimately matters.
Why Cord-and-Plug Connected Sump Pumps Are Generally Discouraged/Prohibited in Elevator Pits
Permanent vs. Temporary
Elevator pits require a permanent solution for water removal. A cord-and-plug connected pump implies a temporary fix.
Reliability
Cord-and-plug connections are inherently less reliable than hard-wired connections. They can be accidentally unplugged, the cord can be damaged, or the plug itself can fail.
Safety
The combination of water and electricity is dangerous. A damaged cord or plug creates a shock hazard. Hard-wired connections offer a more secure and grounded connection.
Code Compliance
As described above, using a flexible cord as a substitute for permanent wiring violates the NEC.
Inspection Issues
Inspectors will almost always flag a cord-and-plug connected sump pump in an elevator pit.
Best Practices / Typical Requirements
Hard-Wired Sump Pump
The sump pump should be permanently wired to a dedicated circuit with proper overcurrent protection.
Junction Box
The wiring should terminate in a suitable junction box located outside the pit (but nearby) or high enough in the pit to be above any potential water level.
Conduit
Wiring within the pit should be run in conduit (e.g., EMT, PVC) for physical protection.
Submersible Pump
Use a submersible pump specifically designed for sump applications.
Automatic Operation
The pump should have a reliable float switch or other mechanism for automatic operation.
Discharge Piping
The discharge piping should be properly sized and routed to a suitable drain.
GFCI Protection
Likely required per 620.85(A) and (B)
How to Find Information in the Code Book
Start with the NEC
Look up Article 620 (Elevators...). Read it thoroughly.2.
Follow the References
Article 620 will likely reference other articles (like Article 400). Follow those references.3.
Use the Index
Look up "Elevators," "Sump Pumps," "Flexible Cords," and "Wet Locations" in the index.4.
Consult the Elevator Code
Review ASME A17.1 / CSA B44 for pit requirements and drainage.
5.
Contact Your AHJ
The most important* step. Ask your local building department or electrical inspector about their specific requirements.
In Summary: While the NEC might not have a single, explicit prohibition against cord-and-plug connected sump pumps in elevator pits, the combination of code requirements, safety concerns, and the need for a permanent solution almost always leads to the conclusion that a hard-wired installation is required. Always consult your local AHJ for definitive guidance. Flag for review