User: Zyb, Location: Maine
Asked on: Monday, November 25, 2024 at 6:36 pm EST
Answered on: Thursday, March 6, 2025 at 5:39 am EST
Question: The existing middle light pole will be move 10 ft, does that mean that I need a junction box or hand hole on the old light pole?
Whether or not you need a junction box or hand hole at the old light pole location depends on a few factors, primarily related to how the wiring is currently run and local electrical codes. Here's a breakdown of things to consider
Reasons why you might need a junction box or hand hole:
Existing Splices
If there are any splices (where wires are connected) currently located inside the old light pole, you'll need to relocate those splices to a suitable enclosure. A junction box or hand hole provides that enclosure. Leaving splices buried underground or exposed is a code violation and unsafe.
Through Wiring
If the wiring runs through the old light pole to other downstream lights or electrical equipment, you can't just cut the wires and move the pole. You'll need a way to reconnect those wires. A junction box/hand hole allows you to create a safe and accessible connection point.
Code Requirements
Electrical codes (like the NEC in the US) typically require that all electrical connections be made inside approved enclosures. This is to protect the connections from the elements, prevent accidental contact, and minimize fire hazards. Your local codes might mandate a junction box/hand hole in this situation.
Abandoned Conductors
If you abandon any conductors in the ground after moving the pole, you might need to cut and cap them properly inside a junction box. Check local codes for rules about abandoned wiring.
Reasons why you might not need a junction box or hand hole
Direct Burial Cable
If the wiring to the light pole is direct burial cable (designed to be buried underground without conduit) and the cable runs directly from the power source to the pole without any splices along the way, and you can reroute the existing cable to the new location, you might be able to avoid a junction box. However, this is highly unlikely and VERY important to verify and get approval.
Continuous Conduit Run
If the wiring is in a continuous conduit run from the power source to the pole and you can extend that conduit run to the new pole location without needing to cut or splice any wires, you might avoid a junction box. However, this is highly unlikely and VERY important to verify and get approval.
Important Considerations
Accessibility
Junction boxes and hand holes must be accessible for future maintenance and inspection. You can't bury a standard junction box underground.
Rating
If the junction box or hand hole is going to be buried or exposed to the elements, it needs to be rated for that environment (e.g., waterproof, NEMA-rated).
Wiring Methods
Make sure the wiring method you use within the junction box/hand hole (e.g., type of connectors, wire terminations) complies with electrical codes.
Depth
If you need to bury the junction box in order to install the new pole, you need to make sure that the light pole base is deep enough for your location and that the junction box is at least 18" below grade.
Recommendations
Consult a Qualified Electrician
This is the most important step. Electrical work can be dangerous, and codes can be complex. A licensed electrician can properly assess the situation, determine the correct wiring methods, and ensure that the work is done safely and in compliance with local codes.2.
Inspect the Wiring
Before you start any work, carefully inspect the wiring at the base of the existing light pole. Determine: Is the wiring in conduit or direct burial cable? Are there any splices within the pole? Where does the wiring originate from? How deep is the wiring?3.
Check Local Codes
Contact your local building department or electrical inspector to find out the specific requirements for your area.
In summary, it's highly probable that you will need a junction box or hand hole when moving the light pole 10 ft, especially if there are any splices in the wiring or if the wiring runs through the pole to other devices. However, the only way to be sure is to consult with a qualified electrician and check your local electrical codes. Flag for review