Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Loadcenter in Bathroom

User: A/A Fuel GTX, Location: WI & AZ

Asked on: Tuesday, August 19, 2025 at 7:56 am EDT
Answered on: Tuesday, August 19, 2025 at 8:07 am EDT

Question: Just to clarify, A loadcenter ( Panel ) in a bathroom prior to the 1990 NEC was not considered a violation?

That is generally correct. The NEC prior to the 1990 edition did not specifically prohibit loadcenters (panels) in bathrooms.However, it's important to understand some caveats and nuances: General Requirements Always Applied

Even though there wasn't a direct prohibition, general requirements of the NEC
still applied. Things like working clearances, adequate access, and proper grounding were always required.

Local Amendments

While the NEC might not have prohibited it outright, local jurisdictions could have amended the NEC to add restrictions. It's crucial to check with the local electrical code in effect at the time of installation.

Practices and Acceptability

While technically
allowed, the practice of installing a panel in a bathroom was generally discouraged and not common due to safety concerns related to moisture and the potential for electric shock. It likely only happened in unusual circumstances.

1990 NEC Change

The 1990 NEC (and subsequent editions) explicitly prohibited overcurrent devices (including panels) in bathrooms.Therefore, while technically

not a violation under the NEC itself prior to 1990
, a loadcenter in a bathroom was generally a bad idea, subject to local codes, and likely to be flagged even under older rules if it lacked proper clearances or grounding. So the answer is likely no, it was not considered a violation unless local amendments. But again, general safety considerations and the potential for local code variations mean this isn't a blanket endorsement. Flag for review

Previous Question Next Question