Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 3/4 " SLB volume for wiring.

User: steve61, Location: Nebraska

Asked on: Thursday, August 21, 2025 at 9:10 am EDT
Answered on: Thursday, August 21, 2025 at 9:11 am EDT

Question: I am installing a 3/4 " SLB with 3 # 6 thhn wires and one # 10 thhn EGC. The inside of the SLB is marked " 3 # 6's Maximum" . Does this mean that I have to install a larger SLB to make room for the # 10 ground wire, Or am I allowed to run the ground wire without exceeding the max fill of the SLB ?

You've identified a tricky situation that requires careful code interpretation. Here's a breakdown of how to approach this and why you likely need a larger SLB

Understanding the Marking and the Issue
"3 #6's Maximum" Marking

This marking is crucial. It means the manufacturer has designed and listed the SLB (Service Entrance LB) with a specific internal volume and wire bending space that
only accommodates three #6 AWG conductors. They have not tested or approved it for any other combination.

Code Compliance is Paramount

Electrical installations must comply with the National Electrical Code (NEC). Failing to do so can lead to safety hazards, failed inspections, and liability.

Why You Likely Need a Larger SLB
1. NEC 314.16(A) - Box Fill Calculations

While you might think you can squeeze in the #10 ground, the NEC requires a formal calculation of box fill. This calculation takes into account the volume occupied by all conductors (including equipment grounding conductors), devices (if any), and internal fittings. You didn't state that the box was a 1 1/2", 2", or 2 1/2 " , However , a 3/4" SLB is NOT manufactured to accommodate 4 wires.2.

NEC 314.16(B) - Conductor Fill

Box fill must follow the table of allowable cubic inch space per conductor that is within 314.16(B) in order to stay within code compliancy.
3.


Listing and Labeling (NEC 110.3(B))

Equipment must be used or installed in accordance with any instructions included in the listing or labeling. The SLB is clearly labeled with a maximum conductor count. This cannot be ignored.

Consequences of Ignoring the Marking
Overfilling

Cramming conductors into an undersized box creates several problems:


Insulation Damage

Wires can be pinched or abraded, leading to shorts or ground faults.

Overheating

Restricted airflow can cause conductors to overheat, further damaging insulation and potentially leading to fires.


Difficult Servicing

Makes future troubleshooting and repairs extremely difficult.

Code Violation

Inspectors will likely fail the installation.

What to Do
1. Replace the SLB

The safest and most code-compliant solution is to replace the 3/4" SLB with a larger one that is explicitly listed and labeled to accommodate the four conductors (3 #6 THHN and 1 #10 THHN). Look for a box that has the appropriately sized trade size with volume requirements to fit all of your conductors within 314.16(B).
2.


Consult with an Electrical Inspector

If you are unsure, contact your local electrical inspector
before proceeding with the installation. They can provide guidance based on your local amendments to the NEC.3.

Consider Alternative Wiring Methods (Less Likely)

In very rare cases, there might be alternative wiring methods that could reduce the conductor count within the SLB, but this is highly unlikely and would require a significant design change.

In summary:
The "3 #6's Maximum" marking on the SLB means exactly what it says. You must* install a larger SLB to accommodate the additional #10 ground wire while staying within code and manufacturer's instructions. Ignoring this warning is a safety hazard and a code violation. Flag for review

Previous Question Next Question