Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Underground Al Service Insulation damage

User: Rex Hungerford, Location: Seattle

Asked on: Friday, September 5, 2025 at 11:06 pm EDT
Answered on: Saturday, September 6, 2025 at 12:16 pm EDT

Question: Underground service wires were damaged by ditchwick. Two had to be spliced. The neutral has a nick in the casing down to the conductor but has not damage the conductor.Is it better to squeeze deox into the insulation, then tape. Or cut the wire and splice with a Polaris NSIISPBS350 2P

Given the situation, here's a breakdown of the best approach and why

The Best Approach: Cut and Splice with Polaris NSIISPBS350 2P

Here's the reasoning: Compromised Insulation is a Problem

The nick in the neutral's insulation, even without conductor damage, is a serious issue. It creates a point of weakness susceptible to moisture, corrosion, and eventual failure. Merely taping it, even with Deox, is a short-term fix that doesn't truly restore the insulation's integrity and long term reliability. Underground cables are subjected to harsh conditions and temporary fixes are not reliable.


Safety First

A compromised neutral creates a potential shock hazard and can disrupt the proper functioning of the electrical system. It can lead to voltage imbalances and equipment damage. A proper splice restores the integrity of the entire neutral conductor.

Long-Term Reliability

Underground splices need to be robust and designed to withstand burial conditions. A Polaris connector is specifically designed for this purpose.


Code Compliance

While it depends on the specific local code, generally, a damaged conductor should be repaired with a listed splicing method, not just insulated.

Why Not Just Deox and Tape?
Band-Aid Solution

This approach is essentially a patch. It doesn't address the underlying weakness in the insulation.


Environmental Concerns

Underground environments are harsh. Tape can degrade over time, allowing moisture and contaminants to penetrate.

Potential Corrosion

Even with Deox, if moisture gets in, corrosion can still occur under the tape.

Steps to Take with the Polaris Connector


De-energize the circuit!
Turn off the power at the source. Verify it's off with a tester. Safety is paramount.2. Excavate

Carefully dig around the damaged area to provide enough working space.3.

Cut the Wire

Cut the neutral wire on each side of the damage, giving you clean, undamaged conductor to work with.4.

Strip the Insulation

Carefully strip the insulation back on each cut end of the neutral, according to the Polaris connector's instructions. Pay attention to the proper strip length.5.

Install the Connector

Insert the stripped wires into the Polaris connector and tighten the screws to the torque specification provided with the connector.

Use a torque wrench.
This ensures a proper and secure connection.6. Insulate and Waterproof

Polaris connectors should be properly insulated and waterproofed. Follow the manufacturer's instructions, which usually involve wrapping the connector with layers of insulating tape and then a waterproofing tape. Kits are often available that include everything needed.7.

Backfill

Carefully backfill the trench, avoiding sharp rocks or debris that could damage the new splice.

Important Considerations



Local Codes and Regulations

Always consult with your local electrical codes and regulations. They may dictate specific requirements for underground splices.

Qualified Electrician

If you are not comfortable working with electrical systems, especially underground ones, hire a qualified electrician. This is critical for safety and ensuring the job is done correctly.


Connector Rating

Make sure the Polaris connector is rated for the correct wire size and voltage of your underground service.*

Direct Burial Rating

Ensure all materials used are specifically rated for direct burial.

In summary, while the "tape and Deox" method might seem easier in the short term, the Polaris splice is the safer, more reliable, and generally code-compliant solution for a damaged underground neutral wire.
Flag for review

Previous Question Next Question