User: ritelec, Location: Jersey
Asked on: Saturday, September 6, 2025 at 9:33 pm EDT
Answered on: Saturday, September 6, 2025 at 9:33 pm EDT
Question: Enclosed are two plastic boxes. One has the entry with a piece of plastic that can be knocked out and one has a entry that is more like a squeeze connector.Can both types support of nm at 12" or would the plastic knock out type need to be 8" away? Thank you
Okay, let's break down the requirements for using NM (nonmetallic-sheathed) cable with these types of plastic boxes. Your question touches on cable support and securing within electrical boxes.
Understanding the Issue: Cable Support and Securing
The National Electrical Code (NEC) and local electrical codes have rules about how NM cable must be supported and secured as it enters an electrical box. The purpose is to prevent strain on the connections inside the box and to protect the cable from damage. The distance from the last point of support to the box is a key factor.
Knock-out Boxes vs. Squeeze Connector Boxes Knock-out Boxes (with removable plastic piece)
These boxes rely on additional connectors (like NM cable clamps) to secure the cable. The knockout is just the hole. You MUST use an NM cable connector appropriate for the size of the cable to secure the cable to the box.
"Squeeze Connector" Boxes
These boxes have built-in strain relief features. They often have flexible plastic fingers or a squeeze-and-release mechanism that grips the cable sheath.
NM Cable Support Requirements (Based on Common NEC Interpretations)
General Rule (NEC 334.30(A))
NM cable must be supported and secured at intervals not exceeding 4 1/2 feet and within 12 inches from every box, cabinet, fitting, or other cable termination.
Knock-out Boxes
With a knock-out box you will always need to use an NM cable connector to secure the cable to the box. This means the 12" rule applies.
"Squeeze Connector" Boxes
The crucial part is whether the "squeeze connector" provides an actual method of support, such as a cable clamp. If the plastic box connector allows the NM cable to be secured to the box, then a 12" support rule can apply. If the connector does not allow the NM cable to be secured to the box, then a NM cable connector will need to be used and again, the 12" rule would apply.
Clarification and Considerations1. Inspect the "Squeeze Connector"
Carefully examine the "squeeze connector" on the box. Does it have a mechanism that positively grips the outer sheath of the NM cable? Can you tighten it to a point where the cable won't easily pull out? The key is that it provides strain relief similar to a regular NM cable connector. The box needs to be listed for securing NM cable and the cable needs to be properly installed.2.
Local Codes Prevail
Always check your local electrical codes. Some jurisdictions may have stricter rules.3.
Installation Quality
Regardless of the type of box, the installation must be neat and workmanlike. The cable should not be stressed or bent sharply as it enters the box.
In Summary
Knock-out Boxes
You
MUST use an NM cable connector. The 12" rule applies. "Squeeze Connector" Boxes
If the box positively secures the NM cable, you can potentially use the 12" rule. If it doesn't truly secure the cable, you MUST use an NM cable connector and follow the 12" rule.
When in Doubt, Secure it Properly: If you are unsure whether the "squeeze connector" provides adequate support, it's always best to use a standard NM cable connector. It's a cheap insurance policy against code violations and potential problems down the road.I strongly recommend consulting a qualified electrician if you're not completely comfortable with these requirements. Electrical work can be dangerous, and code compliance is critical for safety. Flag for review