Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Drag Line

User: Alwayslearningelec, Location: NJ

Asked on: Thursday, September 11, 2025 at 7:20 am EDT
Answered on: Thursday, September 11, 2025 at 7:39 am EDT

Question: When installing empty conduits in which that want a drag line installed what is the drag line usually used for? Pulling in rope if conduit installed is for large conductors?What size drage line is used? Is it dependent on the conduit size and whether data line or electrical?

You're on the right track! Here's a breakdown of drag line use in conduit installation

What is the drag line used for?

The primary purpose of a drag line (also called a mule tape or pull string) installed during conduit installation is to: Facilitate the pulling of a larger pull rope or the conductors themselves at a later time. This is especially crucial in long conduit runs, conduits with bends, or conduits that are difficult to access later. It saves a ton of time and effort compared to trying to fish a pull rope through an empty, potentially obstructed conduit. The drag line acts as a pathway for the stronger rope to follow.

Pulling Rope for Large Conductors

Yes, you are correct. If the conduit is intended for large conductors, the drag line is typically used to pull in a stronger pull rope. That stronger rope is then used to pull the conductors through the conduit.

Drag Line Size and Material Size

The size and material of the drag line are dependent on a few factors:


Conduit Size

Larger conduits generally warrant a stronger drag line.

Anticipated Pulling Force

Heavier conductors or longer/more complex runs require a stronger line.


Material



Nylon

Common for smaller conduits and lighter pulls. Relatively inexpensive.


Polyester

Stronger than nylon, more resistant to stretching, and a good all-around choice.

Mule Tape (Woven Polyester)

Very strong and durable, used for larger conduits and heavier pulls. Often marked with footage for measuring.


Data vs. Electrical

The type of cable (data or electrical) generally doesn't dictate the type of drag line, but it can influence the strength needed. Data cables are usually lighter than power conductors of the same size.

General Guidelines


These are general suggestions. Always consult local codes, project specifications, and consider the specific application. Small Conduit (e.g., 1/2" - 1")

A light nylon or polyester pull string is often sufficient.


Medium Conduit (e.g., 1 1/4" - 2")

A heavier polyester pull string or light mule tape is a good choice.

Large Conduit (e.g., 2 1/2" and up)

Mule tape is almost always recommended.

Important Considerations
Tensile Strength

Check the tensile strength rating of the drag line to ensure it's appropriate for the anticipated pulling force. Err on the side of caution.

Knot Strength

Use proper knots to attach the drag line to the pull rope. A weak knot can significantly reduce the effective strength of the line. Bowlines and figure-eight knots are common and reliable.


Lubricant

Use a cable-pulling lubricant! This drastically reduces friction and makes the pulling process much easier (and safer for the cables).*

Multiple Pull Lines

For very long runs or complex bends, consider installing multiple drag lines. This provides redundancy and can be helpful if one line breaks.

In summary:
The drag line is your friend when installing conduit! Choose the right size and material for the job, and you'll save yourself a lot of headaches later. Flag for review

Previous Question Next Question