Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Strut Attachment

User: Alwayslearningelec, Location: NJ

Asked on: Saturday, September 13, 2025 at 8:18 am EDT
Answered on: Saturday, September 13, 2025 at 8:19 am EDT

Question: So are they show drilling the steel to attach the spanned strut to the flange of the beam?

Based on the context you've provided (show drilling the steel to attach the spanned strut to the flange of the beam), the answer is most likely yes.Here's why: Drilling and Steel Connections

Drilling is a common method for creating holes in steel to facilitate connections. These holes are used to insert bolts or other fasteners.


Spanned Strut and Beam Flange

A spanned strut needs to be securely attached to the beam to transfer loads. The flange of the beam (the wider, flat part) is often the easiest and strongest place to make this connection.

Attaching to the Flange
It is typically easier to drill into the flange than the web (the vertical plate of the beam) since it's more accessible and provides a better surface for the connection. The context implies a direct attachment of the strut to the beam's flange using fasteners, which would require pre-drilled holes.However, without a diagram or more specific information, it's impossible to be 100% certain. There could be alternative methods depending on the design and load requirements. For example: Welding

The strut could be welded directly to the flange. However, your context indicates "drilling" so this is likely not the case.


Clamping

Some specialized clamps might be used in some cases, but these are less common for structural connections in steel.*

Pre-existing Holes

It is possible there are already holes in the beam flange.

Therefore, assuming a standard steel connection where a strut is attached to a beam flange using bolts or similar fasteners, then yes, they are likely drilling holes in the flange to make this attachment.
Flag for review

Previous Question Next Question