Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: EMT

User: jorgeaviles70, Location: New york

Asked on: Thursday, September 25, 2025 at 9:07 pm EDT
Answered on: Sunday, September 28, 2025 at 3:27 am EDT

Question: Can you use empty EMT as supports for lighting ? I know 358.15 (5) said you can’t not but the pipe it not a raice way

You're right to be careful with the NEC and EMT. Let's break this down

NEC 358.12 (5) says you cannot use EMT as a support for light fixtures

Why? Mechanical Strength

EMT is relatively thin-walled. It is not designed to support the weight and vibration of lighting fixtures, especially larger or heavier ones. Over time, the EMT could bend, loosen, or even break, leading to a potentially dangerous situation.


Intended Use

EMT's primary purpose is to act as a raceway for electrical conductors, protecting them from physical damage. Using it as a support structure goes beyond its intended use.

"But the pipe is not a raceway..."


Even if you're not running wires through the EMT, if it is intended to be EMT it still falls under the rules for EMT. So, if you're thinking of using EMT solely as a support structure for lighting, you're still violating the code.

What Can You Do Instead? Dedicated Supports

Use approved methods for supporting lighting fixtures such as Strut or Unistrut, lighting poles, ceiling boxes, J-boxes, etc.


Rigid Conduit

Schedule 40 or Schedule 80 rigid conduit can be used as a support.

Fixtures Rated to be Used for Support

There are certain light fixtures that can be used for support.


Hanging Kits

Many lighting manufacturers offer specific hanging kits designed for their fixtures, which are tested and approved for the task.*

Consult a Qualified Electrician

If you're unsure about the best way to support your lighting fixtures, consult with a licensed and qualified electrician. They can assess your specific situation and recommend a solution that is safe, code-compliant, and effective.

In summary:
While it might seem tempting to use unused EMT as a support, it's generally not a good idea and is likely to violate the NEC. Always prioritize safety and code compliance when working with electrical systems. Flag for review

Previous Question Next Question