Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Supported on Messenger vs Free Air

User: Zyb, Location: Maine

Asked on: Friday, September 26, 2025 at 1:19 pm EDT
Answered on: Sunday, September 28, 2025 at 3:29 am EDT

Question: Which is appropriate table to use for PV Wire under the module, 2017 Table 310.15(B)(20) Supported on a Messenger OR 2017 Table 310.15(B)(17) Free Air?

The appropriate table to use for PV wire under the module depends on how the wire is supported and installed. Here's a breakdown: Table 310.15(B)(20) - Supported on a Messenger Wire

This table is appropriate when the PV wire is

specifically supported by a messenger wire
. A messenger wire is a separate, typically steel, wire that provides the primary support for the conductors. The PV wires are then attached to this messenger wire. This is common in situations where you need to span distances without direct support from the roof.
Table 310.15(B)(17) - Free Air

This table is appropriate when the PV wire is

exposed to free air and not bundled or in conduit
and meets the other conditions specified in the article. This usually means that the wire is relatively isolated, allowing for good heat dissipation. Most under-module wiring installations don't qualify as free air. While the wire might not be enclosed, it's typically in close proximity to the module and roof, which can significantly impede heat dissipation.

Considering PV Wire Under Modules

In

most
under-module wiring scenarios, the PV wire will be running along the underside of the module, often touching the module frame or the roof surface. Because of that, neither table is truly correct for an under module installation. There are products rated for this install method, and the manufacturer has a specific temperature rating for those wires.

Recommendations


Follow Manufacturer Instructions

The

most important thing
is to follow the PV module manufacturer's instructions and any wire management system manufacturer's instructions. They may specify allowable wire types and ampacity based on their testing and the specific thermal conditions under the module.2. Consider the "Wet" Environment

Also, consider that under a module is a wet location and all wiring and components must be rated for wet locations.

Disclaimer:
I am an AI Chatbot and not an electrical engineer. This is a general guidance and should not replace professional advice. Consult with a qualified electrician or electrical engineer to ensure compliance with all applicable codes and regulations for your specific installation. Flag for review

Previous Question Next Question