Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Terminating RMC

User: Alwayslearningelec, Location: NJ

Asked on: Friday, September 26, 2025 at 2:38 pm EDT
Answered on: Sunday, September 28, 2025 at 3:29 am EDT

Question: So am I correct in saying when you terminate RMC into a box/enclosure you could have the following terminations?1. Locknut & bushing2. Hub on end of conduit which would go into a knockout3. Female hub on box so you would just thread the conduit into the hub?

Yes, you are correct. Here's a breakdown and some additional considerations: 1. Locknut & Bushing

This is a very common method.
You insert the RMC through the knockout. A locknut is tightened on the outside of the box to secure the conduit. A bushing (typically plastic, but sometimes metal) is installed on the inside of the box, over the conduit threads, to protect the conductors from abrasion during pulling.

2. Hub on End of Conduit (going into a knockout)

This refers to a conduit body that has a hub attached.


Hub is already attached

Conduit body's like LB's, LL's, and T's typically come with a hub on one end that is simply inserted into the knockout and secured with a locknut.

Hub is attached on the go

Alternatively, this could refer to a coupling or fitting that has a hub that is attached to the conduit. The hub end would then be inserted into the knockout and secured with a locknut.


3. Female Hub on Box (threading the conduit into the hub)

These are often called "threaded hubs" or "integral hubs." The enclosure itself has a threaded hub designed to accept threaded RMC directly. You simply screw the RMC into the hub. This creates a solid and often weatherproof connection.

Important Considerations



Listing and Suitability

Always ensure that the fittings and enclosures you're using are listed for the specific type of conduit (RMC) and the environment (e.g., wet location, hazardous location).

Grounding

Proper grounding is crucial. Using listed grounding bushings or locknuts is important to ensure a reliable ground path, especially when using the locknut and bushing method.


NEMA Rating

The NEMA rating of the enclosure and the fitting must be appropriate for the environment.

Knockout Size

Make sure the knockout size matches the trade size of the conduit.


Weatherproofing

For outdoor installations, use weatherproof hubs, bushings, and seals to prevent water from entering the enclosure.*

Torque:
Tighten locknuts and hubs to the manufacturer's recommended torque specifications.In summary, you've correctly identified the three common methods for terminating RMC into a box or enclosure. Just remember to consider the details of each installation to ensure compliance with electrical codes and best practices. Flag for review

Previous Question Next Question