Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: branch motor circuits to “torque motors” sized per locked rotor current?

User: Isaiah, Location: Baton Rouge

Asked on: Thursday, October 2, 2025 at 7:46 am EDT
Answered on: Thursday, October 2, 2025 at 7:47 am EDT

Question: We have mixer motors and gates that, according to one of our elect engineers, are subject to a locked rotor condition and therefore, the circuit must be sized to locked rotor amps….is this legit?Enviado desde mi iPhone utilizando Tapatalk

Yes, your electrical engineer is correct. It's absolutely legitimate and a fundamental principle in electrical design for motor circuits.Here's a breakdown of why: Locked Rotor Condition (LRC) or Inrush Current

When a motor starts, it's essentially at a standstill. Until it gains speed and develops back EMF (electromotive force), it presents a very low impedance to the power source. This results in a huge surge of current, significantly higher than the motor's normal running current. This surge is called the locked rotor current (LRC) or inrush current. It's often 5 to 8 times the motor's full-load amps (FLA).


Why it Matters for Circuit Sizing



Overcurrent Protection

If you size the circuit protection (circuit breakers or fuses) solely based on the motor's FLA, the inrush current during startup would likely trip the breaker or blow the fuse. The circuit protection needs to be able to withstand this brief but significant current surge.


Conductor Sizing

The conductors (wires) must be large enough to carry the LRC for the duration of the startup without excessive voltage drop or overheating. While the duration is short, repeated startups with undersized conductors can damage the insulation and create a fire hazard.

Equipment Damage

Exposing motors, gates, or mixers to LRC's repeatedly can damage the equipment, shorten its lifespan, and create a safety hazard.


Code Requirements (NEC)

The National Electrical Code (NEC) in the US, and similar electrical codes in other countries, explicitly requires that motor circuits be sized based on LRC for overcurrent protection and conductor ampacity. The exact percentages and rules vary based on motor type, application, and overcurrent device type, but the fundamental principle remains.

Mixer Motors and Gates



Mixer Motors

Mixers often have high starting torque requirements, especially if the material they're mixing is thick or viscous. This means they're more likely to experience a significant LRC during startup.*

Gates

Gates can also require high starting torque, especially if they're large, heavy, or if they've been sitting idle for a while (e.g., rust or debris might increase friction).

In summary, sizing circuits based on locked rotor amps is a standard and essential practice for motor applications. Your electrical engineer is absolutely correct to consider it.
What you should do now

1.

Get the Motor's LRC Data

You need the locked rotor current (LRC) or locked rotor kVA/hp (which can be converted to LRC) from the motor's nameplate or the manufacturer's specifications. You'll need this to correctly calculate the circuit requirements.2.

Consult the NEC (or Your Local Electrical Code)

The NEC (or your local electrical code) provides detailed rules for sizing motor circuits, including conductor ampacity, overcurrent protection, and short-circuit protection. The engineer should be familiar with these requirements.3.

Verify Calculations

Review the engineer's calculations to ensure they are using the correct LRC values and applying the NEC (or local code) rules correctly.4.

Consider Motor Starting Methods

In some cases, if the LRC is excessively high, you might consider using reduced-voltage starters (e.g., soft starters, autotransformers) to limit the inrush current. This can reduce the required circuit size and potentially save money.5.

Document Everything:
Keep thorough documentation of all calculations, motor specifications, and circuit design decisions.Ignoring LRC in motor circuit design is a recipe for problems, including equipment failure, nuisance tripping, and potential safety hazards. Listen to your electrical engineer and ensure the circuits are properly sized. Flag for review

Previous Question Next Question