User: Jimmy7, Location: Boston, MA
Asked on: Thursday, October 2, 2025 at 8:28 am EDT
Answered on: Thursday, October 2, 2025 at 8:45 am EDT
Question: If I want to check how well a pool is bonded I should measure the NEV, correct? I think I saw a video that Mike put out about it a while back. Does it matter where you put your reference point? If I remember correctly Mike put a screwdriver or a stake in the ground near the meter socket. When checking the different locations with your meter do all the voltages need to be exact, or can they vary a little? What's acceptable? This is not for certification purposes, but If I ever wanted to check if a pool is bonded properly
You're on the right track! Let's clarify how to check pool bonding and address your questions.
Yes, you want to measure the NEV (Nuisance Voltage) or voltage difference between metallic components around the pool. This is often referred to as checking the "equipotential bonding" of the pool area.
Here's a breakdown
What are you checking? You're verifying that all metallic parts around the pool (metal pool components, fences, ladders, lights, pumps, electrical panels, etc.) are bonded together in a way that minimizes voltage differences between them. The goal is to create a uniform electrical potential so that a person in the pool isn't exposed to voltage gradients that could lead to electric shock. How to measure NEV (Nuisance Voltage)
Meter Setting
Use a multimeter set to AC Volts, with a resolution down to millivolts (mV).2.
Reference Point
This is where the metal rod comes in. You want the rod to be as close to the pool as practical without being in the water. You want to avoid an existing piece of metal near the pool because you are checking how good the bonding is to that piece of metal. You want your earth rod to be able to provide you with a better reading for the surrounding area.3.
Measurements
Place one probe of your multimeter on the reference point metal rod. With the other probe, touch various metallic parts around the pool area (pool light niches, metal ladders, metal handrails, metal fence posts, metal parts of the pump housing, the pool electrical panel, etc.). Record the voltage reading at each location.
Interpreting the Readings (What's Acceptable)
Ideally, you want to see readings as close to 0.0 mV as possible. This indicates excellent bonding. A variance of 100mV or less is very acceptable. A variance between 100mV-500mV is acceptable, but would warrant further investigation. Any value above 500mV should be investigated and corrected immediately. This would indicate poor bonding, loose connections, or corrosion. You would want to consult with a qualified electrician or pool professional.
Important Considerations
Safety First
Always turn off the power to the pool equipment before making any electrical measurements. This is crucial to avoid electric shock.
Qualified Professional
If you are uncomfortable with electrical testing or if you find significant voltage differences, consult a qualified electrician or pool professional.
Bonding is Continuous
Remember that the bonding wire should be one continuous wire, not cut. Connections should be made with listed connectors and not standard wire nuts.
Disclaimer: I am an AI Chatbot and not an electrician. This information is for educational purposes only and should not be substituted for advice from a qualified professional. Working with electricity can be dangerous; always prioritize safety. Flag for review