Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 250.21 B, Ground detectors

User: Jpflex, Location: Victorville

Asked on: Wednesday, October 8, 2025 at 4:19 pm EDT
Answered on: Wednesday, October 8, 2025 at 4:20 pm EDT

Question: For ungrounded systems requiring ground fault detectors for ungrounded systems operating at not less than 120 volts and at 1000 volts or less, does this factor in whether "operation" is factoring utilization secondary or supply primary?In other words as long as primary or secondary exceeds 1000 volts we no longer are required to install ground detectors?An old ungrounded delta transformer i worked on was 4500 vac primary to 480 VAC secondary. The system did not have ground fault detectors. I assume this set up was correct because the primary side of the system exceeded 1000 vac. Is this correct?The code doesnt destinguish the primary from the secondary portion of the system.

You're asking a very important question about the interpretation of the National Electrical Code (NEC) requirement for ground fault detectors on ungrounded systems. Let's break it down.

Understanding the NEC Requirement (Generally)

The NEC (specifically Article 250.21) generally requires ground fault detection on ungrounded systems under certain conditions. The intent is to provide an indication of the first ground fault on an ungrounded system. This is because, in an ungrounded system, a single ground fault doesn't interrupt the circuit. However, it raises the voltage to ground on the other phases and creates a much higher risk of a second fault, which will cause a short circuit and potentially a severe event.

Your Specific Scenario: 4500 VAC Primary to 480 VAC Secondary

You are correct. Based on your description, it appears that the lack of ground fault detection was likely compliant with the NEC. The key phrase here is "operating at not less than 120 volts and at 1000 volts or less." This voltage range applies to the system voltage. The NEC typically refers to voltage between conductors (phase-to-phase) when specifying voltage requirements.Here's why: Primary Voltage Exceeds 1000V

The primary side of your transformer operated at 4500 VAC. Since this exceeds 1000 volts, the ground fault detection requirement would not apply to that portion of the system.


Secondary Voltage is Within Range

The secondary voltage of 480 VAC is between 120V and 1000V. However, the overall system includes the higher primary voltage, and that seems to be the deciding factor.

Code Interpretation
: While not explicitly defined as primary vs secondary, common interpretation, and the overall intent of the code, suggests that as long as part of the system is above 1000 VAC, the ground detection requirement for ungrounded systems is not applicable.

NEC 250.21(B) states

Ungrounded systems supplied by other than separately derived sources shall be equipped with a ground fault detection system that indicates the presence of a ground fault on the system.A ground fault detection system shall not be required where the system is used exclusively to supply equipment that is limited to the following:(1) Equipment that is required to be grounded by 250.110.(2) Equipment that is supplied by a circuit that is isolated from ground.

Important Considerations and Caveats



Specific NEC Edition

Code requirements change over time. It's essential to refer to the specific edition of the NEC that was in effect when the installation was originally done, or the edition in effect where the system is currently located, if different. Older codes might have had different requirements.

Local Amendments

Local jurisdictions often amend the NEC. Always check with your local electrical inspector or authority having jurisdiction (AHJ) for any local requirements that might be more stringent than the NEC.


Engineering Judgement

Even if not required by the NEC, good engineering practice might suggest including ground fault detection for enhanced safety and system reliability, especially if the system serves critical loads.

Disclaimer:
I am an AI chatbot and cannot provide definitive legal or code compliance advice. Always consult with a qualified electrical engineer or licensed electrician for any electrical installations or interpretations of the NEC. They can provide specific guidance based on your unique situation and the applicable code edition. Flag for review

Previous Question Next Question