Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Ami smart meter installers

User: qwe123, Location: usa

Asked on: Tuesday, October 14, 2025 at 7:57 am EDT
Answered on: Tuesday, October 14, 2025 at 7:58 am EDT

Question: Poco upgrading to ami smart meters and has their contractors installing them.Im guessing they are not electricians or linesman.Is there any reason for them to touch the conductors or loosen the lugs during a smart meter install?Im assuming they are just trained to pull them out and push them in and anything else inside the meter can is left alone.Is that a fair assesment?

You've raised a valid concern, and your assessment is generally accurate, but let's break it down: Contractor Skill Level

You're right to assume that the contractors installing smart meters are likely
not licensed electricians or linemen. They receive specific training for the meter replacement process. Their training focuses on safely removing and replacing the meter itself.

Normal Procedure

In a standard smart meter installation, the contractor should

NOT
be touching the conductors (wires) or loosening the lugs (connectors). The process should involve:1. Power Shut-Off

The contractor should kill the power to the meter, usually by remote shutoff or a disconnect switch, or on some cases by pulling the main breaker.2.

Meter Removal

Carefully removing the old meter from its socket.3.

Visual Inspection

A quick visual inspection of the meter base and wiring.4.

Meter Installation

Plugging in the new smart meter.5.

Power Restoration

Turning the power back on.6.

Verification

Checking that the meter is functioning correctly and communicating.

Reasons for Touching Conductors or Lugs (RARE, but POSSIBLE)

There are some
uncommon situations where a contractor might need to touch conductors or lugs. This should be the exception, not the rule, and would ideally involve a qualified electrician:

Corrosion or Damage

If the contractor observes significant corrosion, damage, or loose connections at the lugs or wiring, they should report it. However, they should not attempt to fix it themselves unless they are qualified and authorized to do so. This would require notifying the homeowner and possibly the utility company, who would then send a qualified electrician.

Non-Standard Meter Base

In rare cases, an older or unusual meter base might require minor adjustments for the new meter to fit properly. Again, this should ideally be done by a qualified electrician, but in some cases, the contractor might have been trained to do basic adjustments
if it's part of their approved procedure.

Safety Hazard

If the contractor identifies an immediate safety hazard (e.g., exposed wires, evidence of overheating), they might disconnect the power and notify the appropriate authorities. They would not necessarily repair the hazard themselves.

Your Assessment

Your assumption that they are trained to "pull them out and push them in" and leave everything else alone is largely correct
in a standard installation.

What to Do If You See Them Touching Conductors/Lugs


Ask Questions

Politely ask the contractor
why they are touching the conductors or lugs. Understand their explanation.2.

Document

Take photos or videos of the work being done.3.

Contact the Utility Company

If you are uncomfortable with the explanation or the work being performed, immediately contact your utility company. Explain your concerns and ask them to send a qualified electrician to inspect the installation.4.

Stop the Work

If you feel there is an imminent danger, you have the right to ask the contractor to stop work until a qualified electrician can assess the situation.

In summary:
While the vast* majority of smart meter installations are simple replacements, there's always a small chance of complications. It's good to be aware and observant. If you have any doubts or concerns, contacting the utility company is always the best course of action. Flag for review

Previous Question Next Question