User: Alwayslearningelec, Location: NJ
Asked on: Wednesday, October 15, 2025 at 1:34 pm EDT
Answered on: Wednesday, October 15, 2025 at 1:34 pm EDT
Question: To me this looks like a piece of LFMC going into the disconnect switch. What does look like it's going through at the roof? Also looks like it's full of tar.
Okay, let's break down what we can see in the image you're describing. I'm assuming you're talking about an electrical installation.
Here's my assessment based on your description
LFMC into Disconnect Switch
You're likely correct. LFMC stands for Liquidtight Flexible Metal Conduit. It's commonly used for connections to equipment where some flexibility is needed and protection from liquids is desired. It looks like a flexible metallic conduit going into the disconnect switch.
Roof Penetration
Without seeing the image, it's harder to say definitively what is going on with the roof penetration. Based on "looks like its full of tar" that suggests there is likely a weatherproof seal. Here are some possibilities:
Weatherhead
A weatherhead is a curved fitting at the top of a conduit that directs wires downward, preventing rain from entering the system. These are used when bringing overhead service wires into a building. However, the tar reference makes me think its unlikely.
Roof Flashing/Boot
If the conduit is simply passing through the roof (not bringing service wires in), it should have a proper roof flashing and/or boot. This is a shaped piece of metal or rubber that seals around the conduit where it penetrates the roof to prevent leaks. The "tar" you are seeing is likely a sealant (roofing tar or similar) used to further waterproof the area around the flashing/boot. This is very common.
Improper Sealant
It's possible that the "tar" is simply a poorly applied sealant attempt. This would be a cause for concern, as it might not be a long-term solution and could lead to leaks.
Tar
As mentioned above, the "tar" you see is likely:
Sealant
Used to waterproof the roof penetration.
Possible Concerns/Things to Consider
Condition of the LFMC
Check for any signs of damage to the LFMC, such as cracks, rust, or deterioration of the liquidtight jacket.
Proper Support
Ensure the LFMC is properly supported according to electrical code requirements. Long unsupported runs can sag and put stress on the connections.
Weatherproofing
The roof penetration is the biggest potential issue. Make sure the flashing/boot is in good condition, properly sealed, and not showing any signs of leaks.
Code Compliance
Depending on your location, electrical installations must adhere to certain codes (like the National Electrical Code in the US).
Disclaimer: I am an AI chatbot and cannot provide professional electrical advice. Always consult with a qualified electrician for any electrical work or if you have concerns about the safety and compliance of an electrical installation.* Flag for review