User: electrofelon, Location: Cherry Valley NY, Seattle, WA
Asked on: Tuesday, October 21, 2025 at 10:34 am EDT
Answered on: Tuesday, October 21, 2025 at 10:35 am EDT
Question: Can the generator two wire start conductors be run with the power conductors? What type of circuit conductors are these?
Let's break this down
Can the generator two-wire start conductors be run with the power conductors?
Generally, yes, they can, but with some important considerations and requirements: Insulation Rating
The start conductors must have an insulation rating equal to or higher than the voltage of the power conductors. This is crucial for safety and to prevent faults. You can't use a low-voltage control wire bundled with high-voltage power conductors.
Physical Separation
While running them in the same conduit or cable tray is often permitted, maintaining some physical separation (e.g., using cable ties to keep them distinct) can be good practice. This helps with troubleshooting later.
NEC Compliance
Always refer to your local National Electrical Code (NEC) or relevant electrical code for specific regulations in your jurisdiction. The NEC may have specific articles covering generator wiring and control circuits. Look at Article 701 (Legally Required Standby Systems), 702 (Optional Standby Systems), and 700 (Emergency Systems).
What type of circuit conductors are these?
The two-wire start conductors are generally considered control circuit conductors. Control Circuit
A control circuit carries the electrical signals that control the operation of the generator. The start circuit specifically controls the starting and stopping of the generator's engine.
Low Voltage, Low Current
Typically, these control circuits operate at relatively low voltages (e.g., 12VDC, 24VDC, or 120VAC) and carry low currents. They are signaling circuits, not power-carrying circuits in the same way the output conductors are.
Class 1 or Class 2 Circuits
Based on the voltage and power limitations, these circuits often fall under the category of Class 1 or Class 2 circuits as defined in the NEC. This classification impacts the wiring methods and overcurrent protection requirements.
Important Considerations
Manufacturer's Instructions
Always follow the generator manufacturer's instructions. They will specify the required wiring methods and conductor types for the control circuits.
Overcurrent Protection
The control circuit conductors must have appropriate overcurrent protection (fuses or circuit breakers) sized according to the conductor's ampacity. This is critical to protect the wiring in case of a short circuit.
Derating
If running multiple conductors in a conduit, consider derating the ampacity of all conductors according to the NEC tables.
Marking
It's a good practice to clearly label the control circuit conductors at both ends to identify their function.*
Professional Installation
Generator installations are complex. It's strongly recommended to have the installation performed by a qualified and licensed electrician who is familiar with the NEC and local regulations.
In summary: While you can generally run the generator start conductors with the power conductors, attention to insulation rating, overcurrent protection, and adherence to the NEC and manufacturer's instructions is crucial for a safe and code-compliant installation. These are considered control circuit conductors, typically low voltage and low current, governing the starting and stopping of the generator. Flag for review