User: seanyboy1013, Location: NJ
Asked on: Monday, October 27, 2025 at 2:01 pm EDT
Answered on: Monday, October 27, 2025 at 2:48 pm EDT
Question: We have a Murray 125A panel in a shed we are turning into a break room and it has 3 20 amp breakers, a 15 amp breakers and the 2 pole 20 amp breaker. You can see on the cover that there are only 6 spots, but when I take the cover off it looks like there are 2 additional spots for breakers. But in the diagram it also only shows 6 spots. SO i guess I am just seeing if I can add 2 breakers to this panel or no? They want to have a microwave and a fridge in there so need them on their own circuits. Apologies I have pictures but not sure how to upload them
You're right to be cautious. Just because it looks like there are extra spaces doesn't automatically mean you can add breakers. Here's how to figure this out
Understanding Breaker Panel Spaces and Circuits:
Spaces vs. Circuits
A breaker panel has spaces (the physical slots where you plug in breakers) and a maximum number of circuits it's designed to handle. Just because there are empty spaces doesn't guarantee you can add circuits.
Panel Rating
The front cover of the panel should list the maximum number of circuits the panel can handle (not just the amps). You mentioned it shows 6. This is a critical piece of information.
Steps to Determine if You Can Add Breakers
Confirm Maximum Circuits
Double-check the panel cover, or look inside the panel door, for any labels stating the maximum number of circuits the panel is designed for. It's usually written as "Max. Circuits: X" or something similar.2.
Check for Tandem Breakers
Sometimes, you can use "tandem" or "double-stuff" breakers to fit two circuits into a single breaker space. These are thinner breakers that take up half the width of a standard breaker. However, the panel MUST be rated to accept tandem breakers, and even then, often only certain spaces can accept them. The panel diagram on the inside of the cover will usually indicate if it supports them. If the breaker diagram inside the cover is the same as what you see on the cover, it means that your panel doesn't accept the tandem breakers.3.
Examine the Bus Bars
Carefully (with the power OFF and using proper safety precautions!), examine the metal "bus bars" inside the panel where the breakers connect. Look for the number of notches on the bus bars and if the notch that your breakers connect to is able to accept the tandem breakers.4.
Consult a Qualified Electrician
This is the most important step. If you're unsure about anything, do not attempt to add breakers yourself. A qualified electrician can properly assess your panel, determine if it's safe and code-compliant to add circuits, and do the work correctly.
Why Adding Circuits is a Big Deal
Overloading
Adding too many circuits to a panel not designed for them can overload the panel's capacity, leading to overheating, breaker tripping, and potentially dangerous electrical fires.
Code Compliance
Electrical work must comply with local electrical codes, which are designed to ensure safety. An electrician will know the codes and make sure the work is done correctly.
Regarding the Microwave and Fridge
You are correct that a microwave and refrigerator each need their own dedicated circuits to avoid overloading.
In summary:
Based on what you've described, it sounds like your panel is likely limited to 6 circuits. However, without a physical inspection, I cannot give a definitive answer. Do not add breakers without first consulting with a qualified electrician. They will be able to inspect the panel, determine its capacity, and advise you on the safest and most code-compliant way to add the circuits you need. Flag for review