User: JovialBulge, Location: New England
Asked on: Sunday, November 2, 2025 at 10:08 pm EST
Answered on: Monday, November 3, 2025 at 1:14 am EST
Question: If you were to have a panel with multiple vfds would you:a) take the input current ratings for each of the vfds and add them together to get the calculation according to 30.2.2 c)b) same as a) then multiply by 115%c) take the highest rated input current from all vfds (this section of code only mentions a vfd and does not use vfd(s) so I listed this as an option) and add that with all of the other remaining motor FLAs from Table 50.1 for the other motors that are vfd controlled.d) same as c) then multiply by 115%30.2.2A molded-case switch, a switch unit, a fused power circuit switch, a pullout switch, and an open or enclosed switch shall have:c) For one or more motors or for one motor and any other load(s), an ampere rating or a horsepower rating with an equivalent full-load current:1) Not less than 115 percent of the full load current ratings of all motors, in accordance withTable 50.1 or the input current rating of a variable speed drive plus the full-load currents ofall other loads
Based on your provided code snippet (30.2.2 c) and the common interpretation of such regulations, the best answer is (a): Take the input current ratings for each of the VFDs and add them together to get the calculation according to 30.2.2 c)
Here's why: "All motors" and "Input current rating of a variable speed drive plus the full-load currents of all other loads" implies summing the inputs of multiple VFDs. If the code intended to only consider one VFD, it would likely use singular language consistently. The phrase "all motors" suggests handling multiple VFDs, as each VFD controls a motor. It's likely that because VFDs are also a type of load, that all of the current from each VFD must be added in accordance with the first portion of the statement in 30.2.2 c) which references "all motors". Option (c) is incorrect because code 30.2.2 c) references all motors and vfds. Options (b) and (d) are incorrect Because the 115% is in reference to all of the motor full load currents, and not the input currents of all the variable speed drives.
In summary, to ensure compliance and safety when dealing with multiple VFDs, add their input current ratings. Flag for review