Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Power operated service disconnects.

User: Pinnie, Location: Ohio

Asked on: Monday, November 10, 2025 at 9:37 am EST
Answered on: Monday, November 10, 2025 at 9:38 am EST

Question: In 230.90(a) it says “Single-pole breakers, grouped in accordance with 230.71(B), shall be considered as one protective device”Does this mean you can use multiple single-pole breakers to disconnect each ungrounded service conductor, or am I misreading this?

You're right to question that and you're on the right track. Here's the breakdown of what that section means and how it relates to service disconnects: 230.90(A) - Overcurrent Protection

This section is specifically about

overcurrent protection
(fuses and breakers). It is NOT the same as a service disconnecting means (230.71). It states that when single-pole breakers are grouped per 230.71(B), they will be considered one protective device for overcurrent protection.
230.71 - Maximum Number of Disconnects

This section limits the number of service disconnecting means (the actual switches/breakers you use to cut power to the building).

230.71(B) - Grouping

This is the key. 230.71(B) allows a
limited number of service disconnects grouped together in a single location. Typically, the code allows up to six service disconnects (main breakers or fused switches).

So, can you use multiple single-pole breakers to disconnect each ungrounded service conductor?


The answer is Yes, but only under VERY specific circumstances and the setup MUST comply with 230.71(B).

You could use a group of single-pole breakers as the overcurrent protective device for a service, and also as the service disconnecting means, if each ungrounded service conductor has its own breaker.However, keep in mind that the setup must still comply with 230.71(B), in the sense that the group of breakers counts as one service disconnect. So if the setup uses more than one group of single-pole breakers for the service, it could exceed the maximum number of disconnects allowed.

Example Scenario1. Small Building, 120/240V Single-Phase Service

You could use two single-pole breakers that are tied together with a handle tie. When the handle tie is in place, both breakers trip together, effectively disconnecting both ungrounded conductors simultaneously.

In conclusion

230.90(A) says a group of single-pole breakers can be treated as one for overcurrent protection purposes. 230.71(B) is what determines if you can use grouped single-pole breakers as the service disconnect means. The total number of disconnects allowed (including the single-pole breaker group) must not exceed the limit specified in 230.71.

Always consult the full NEC code and your local inspector for clarification and to ensure your installation meets all requirements.
Disclaimer: This information is for general guidance only. Always consult the latest edition of the National Electrical Code (NEC) and a qualified electrician for specific applications and code compliance. Flag for review

Previous Question Next Question