User: Cartoon1, Location: Florida
Asked on: Monday, November 10, 2025 at 7:12 pm EST
Answered on: Monday, November 10, 2025 at 7:13 pm EST
Question: Hello all. My understanding is that you can put an electrical panel behind a door, as long as the clearance is there when you close the door.My question is: if the electrical panel is surface mounted, where the closet door touches the panel when opened. So the closet door doesn't fully open at 90 degrees, maybe closer to 85degrees. is this considered a violation? (Assuming you put a door stop so you don't touch the panel)Thank you
Okay, let's break this down. You're asking a very specific, and common, question.
The Core Requirement: Working Space
The National Electrical Code (NEC) (and most local codes based on it) prioritizes working space around electrical equipment. This working space is intended to provide enough room for a qualified electrician to safely access and work on the panel. Depth
The depth of the working space (how far you need to be able to step back from the panel) is dictated by voltage and other factors (see NEC 110.26). For a typical residential panel (120/240V), this depth is usually 3 feet.
Width
The width of the working space must be at least 30 inches wide or the width of the equipment, whichever is greater (NEC 110.26(A)).
Height
The working space must be clear and extend from the grade, floor, or platform to a height of 6 1/2 feet or the height of the equipment, whichever is greater (NEC 110.26(E)).
Door Interference: The Key Issue
Your scenario raises the question of whether the door impedes this working space. Here's how to think about it:1. Is the working space compromised by the door's swing? If, when the door is open (even if it's not a full 90 degrees), you can still stand directly in front of the panel and have that 30" wide x 3' deep x 6 1/2' high working space clear, then it might be acceptable. If the door, even at 85 degrees, significantly encroaches on that space, it's a problem.2. Does the door prevent access? If the door, even at its maximum opening angle, blocks a qualified electrician from safely accessing the panel, it's definitely a violation. Imagine someone needing to quickly shut off a breaker in an emergency – can they reach the panel unimpeded?3. Door Stop Considerations
A door stop is a good idea to prevent damage to the panel, but it doesn't magically solve the code compliance issue. The code is concerned with usable working space, not just whether the panel is physically protected from the door.
Why It's Likely a Violation
Reduced Maneuverability
An 85-degree door swing, especially in a confined space like a closet, is highly likely to restrict movement and make it difficult to access the panel comfortably and safely. Imagine trying to troubleshoot with tools and test equipment while squeezed between a partially open door and the panel.
Potential Hazard
In an emergency, that slight obstruction could be critical.
Recommendations
Consult a Local Electrical Inspector
This is the best course of action. They have the authority to interpret the code for your specific situation and location. Take pictures of the panel's location and the door's swing, and explain your setup.2.
Consider Moving the Panel
If possible, relocating the panel to a more accessible location would be the ideal solution.3.
Reconfigure the Door
Could you use a different type of door (e.g., a bifold door, a pocket door, or a door that swings outward)?4.
Adjust the Door Swing
Could you change the hinges so the door swings in the opposite direction? (Sometimes this isn't practical due to room layout).
In summary, while technically the rule is about clearance with the door closed, the spirit and intent of the code (and common sense) is to ensure safe and unobstructed access* to the panel at all times. A door that opens only 85 degrees and impinges on the working space is very likely to be considered a violation by most inspectors.
Good luck! Let me know if you have more questions. Flag for review