Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: What are these holes for?

User: marmathsen, Location: Seattle, Washington ...ish

Asked on: Monday, November 17, 2025 at 11:59 pm EST
Answered on: Monday, November 17, 2025 at 11:59 pm EST

Question: What are these holes for on this Arlington F102 box?

The holes on an Arlington F102 box are primarily for nailing or screwing the box to a stud or mounting surface.Here's a breakdown of what you'll typically find: Side Holes

These are the most obvious and common. They are positioned on the sides of the box so you can drive nails or screws directly into a stud that is running beside the box.


Bottom or Top Holes

Some boxes have holes in the bottom or top. This allows you to screw the box to a floor joist or ceiling joist for overhead installations.*

Knockouts:
The box likely has knockouts (round indentations). These aren't technically holes until you knock them out, but they are used to create an opening for running electrical wire into the box. You'd remove one of these knockouts depending on where your wire is coming from (side, back, etc.).Without seeing a picture of the exact box you have, it's hard to say definitively, but the above covers the most common reasons for holes and knockouts on a box like the Arlington F102. Flag for review

Previous Question Next Question