Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Nicked - ringed 750 MCM Aluminum Feeders

User: BSuba, Location: Henrico County, VA

Asked on: Tuesday, February 1, 2011 at 5:26 pm EST
Answered on: Tuesday, May 14, 2024 at 1:02 am EDT

Question: Recently I inspected an installation where the terminations were nicked - ringed by the knife that was stripping the insulation off the conductor. When I was an apprentice this was a capital offense. How does this impede or inhibit current flow? Does this create a hot spot along the conductor at this point? What can be done if the conductor is not long enough to cut and properly terminate short of repulling - or adding a butt splice with additional conductor length added at that time.

How Does Ringing Impedes Current Flow

Nicking or ringing the conductor during insulation stripping can damage the metal strands, reducing the cross-sectional area available for current flow. This creates a localized constriction, increasing the resistance to current.

Hot Spot Creation

The constriction caused by the nick or ring can act as a bottleneck, restricting the flow of electrons. This can lead to the accumulation of heat at that point, creating a hot spot. Hot spots can weaken the conductor further, potentially leading to failure.

If the Conductor is Not Long Enough

If the conductor is not long enough to cut and properly terminate without shortening it significantly, the following options can be considered:

Insulation Repair

Use heat-shrinkable or liquid electrical tape to insulate and protect the nicked area. This can help prevent further damage and reduce the risk of a hot spot.


Butt Splice with Additional Length

Add a butt splice with additional conductor length to compensate for the lost length due to cutting and stripping. Ensure that the splice is properly insulated and secured to prevent any contact with other conductors or surfaces.

Terminal Extension

Use a terminal extension that allows for connecting additional conductor without cutting the existing one. This can extend the length of the conductor and provide a secure termination point for the nicked portion.

Additional Considerations:
If the ringing is severe or close to the end of the conductor, it may be necessary to replace the entire conductor. It's important to note that any repair or modification to electrical conductors must adhere to all applicable electrical codes and standards. The inspector should document the severity of the ringing and recommend appropriate corrective actions to ensure the safety and integrity of the installation. Flag for review

Previous Question Next Question