Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: using one pole of a two pole breaker

User: arnettda

Asked on: Tuesday, February 1, 2011 at 9:34 pm EST
Answered on: Tuesday, May 14, 2024 at 1:03 am EDT

Question: I have a PV system that calls for a single pole 60 amp breaker. Can I use a two pole breaker and only use on leg of it? I think a two pole 60 is around $12 and I bet a 0ne pole is alot more. Thanks

No, you cannot use a two-pole 60 amp breaker and only use one leg of it for a 60 amp PV system. Here are the reasons why

Safety:
Two-pole breakers are designed to protect two separate circuits simultaneously. Using only one leg of a two-pole breaker for a single-phase load, such as a PV system, can create an unsafe condition. If a fault occurs on the unused leg of the two-pole breaker, the breaker will not trip, leaving the circuit exposed to overcurrent and potential fire hazards.

Electrical Code Compliance

The National Electrical Code (NEC) requires that the ampacity of a circuit breaker must match the amp rating of the load it is protecting. Installing a two-pole 60 amp breaker for a 60 amp PV system would violate this code requirement.

Voiding of Warranty

Using a two-pole breaker for a single-phase load, such as a PV system, may void the manufacturer's warranty for the breaker.

Cost Effectiveness

While a two-pole 60 amp breaker may be slightly cheaper than a single-pole 60 amp breaker, the cost difference is likely negligible. It is not recommended to sacrifice safety and code compliance for a small cost savings.

Recommendation:


To ensure the safe and proper operation of your PV system, it is highly recommended to use a single-pole 60 amp breaker. This will provide the necessary protection for your system and meet all electrical code requirements. Flag for review

Previous Question Next Question