Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: FCI FC-72 RDF Releasing Device Interface

User: el Cid, Location: San Francisco Bay Area

Asked on: Wednesday, February 2, 2011 at 11:21 am EST
Answered on: Tuesday, May 14, 2024 at 1:03 am EDT

Question: I have a FC-72 panel set up for suppression. When testing the abort switch the RDF card indicates (yellow led) when an abort has been activated but does not abort.Anyone have any paperwork on this card?Any suggestions are appreciated.

Paperwork on FC-72 Panel RDF Card

[FC-72 Inspector's Guide](https://www.fmf.com/wp-content/uploads/2020/05/FC-72-Inspectors-Guide.pdf) [FC-72 Emergency Voice Panel Programmer's Reference Manual](https://www.fmf.com/wp-content/uploads/2020/05/FC-72-Emergency-Voice-Panel-Programmers-Reference-Manual.pdf)

Possible Solutions for Abort Switch Issue



Check Wiring

Ensure that the abort switch is properly wired to the RDF card.


Verify Abort Switch Functionality

Test the abort switch independently to confirm that it is working correctly.

Inspect RDF Card Connections

Check all connections to and from the RDF card for loose or damaged wires.


Update Firmware

Ensure that the RDF card is running the latest firmware. Refer to the FC-72 documentation for instructions on firmware updates.

Check Suppression Configuration

Verify that the FC-72 panel is configured for suppression mode. The RDF card should indicate an active abort when the abort switch is activated.


Inspect the Relay

The RDF card controls an abort relay. Check if the relay is functioning correctly by activating the abort switch and measuring the relay output voltage.

Replace the RDF Card

If all other troubleshooting steps fail, consider replacing the RDF card.

Additional Tips:
Refer to the FC-72 User Manual for detailed troubleshooting procedures. Contact the manufacturer, Fike Fire Protection, for technical support. Ensure that the panel is in a test mode before activating the abort switch.* Reset the panel after performing troubleshooting steps. Flag for review

Previous Question Next Question