Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Manhole power

User: sbutler, Location: North Charleston, SC

Asked on: Wednesday, February 2, 2011 at 2:26 pm EST
Answered on: Tuesday, May 14, 2024 at 1:04 am EDT

Question: Situation: I have manholes with 13.8kV feeders routing through them. There is a 480VAC sump pump in the bottom of the manhole. There are 2" conduits in place for the 480VAC feed (separate but in same duct bank as 13.8kV feeders). The contractor wants to install LFMC versus RGSC from the 2" entering the ductbank to the pump controller to save money, make it easier and quicker install. Is this legal or is RGSC required?Thanks for any and all replies.

NEC Requirements for Wiring in Manholes

According to the National Electrical Code (NEC), Article 501.10(A), raceways installed in manholes with medium-voltage (over 600 volts) conductors must be approved for use with high-voltage cables.

RGSC Conduit Requirements

Rigid galvanized steel conduit (RGSC) is specifically approved for use in manholes with high-voltage cables, as it is: Mechanically strong Resistant to corrosion Provides protection from physical damage

LFMC Conduit

Liquid-tight flexible metal conduit (LFMC) is primarily designed for use in flexible applications and is not specifically approved for use in manholes with high-voltage cables. It is more vulnerable to damage and may not provide adequate protection.

Other Considerations

The 480VAC sump pump circuit voltage is below the 600-volt threshold for high-voltage considerations.* However, since the conduit bank contains 13.8kV feeders, it is still classified as a high-voltage area.

Conclusion



Based on the NEC requirements and the presence of high-voltage cables, RGSC conduit should be used for the 480VAC sump pump feed from the 2" entering the duct bank to the pump controller.
Recommendation:

Inform the contractor that LFMC is not acceptable for this installation due to NEC safety regulations and the presence of high-voltage cables. Insist on the use of RGSC conduit for the 480VAC sump pump circuit. Flag for review

Previous Question Next Question