Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Using Bus Duct with tap rule

User: PhaseShift, Location: NJ

Asked on: Wednesday, February 2, 2011 at 4:48 pm EST
Answered on: Tuesday, May 14, 2024 at 1:04 am EDT

Question: If you keep tapping off of a bus structures with the same size bus does the tap rule even come into play?For instance lets say I have a 400 bus. I then tap this bus with another 400A bus to form bus #2. I then tap bus #2 with another 400A bus to form bus #3. Since its the same size bus do we need to be concerned with the tap rule as long as our upstream protective device is less than 400A? In other words this wouldn't be considered "tapping a tap"?Would tap rule only come into play if we were tapping busses with cables or buses of a lesser size than the origonal bus?

Yes, the tap rule still applies even if you keep tapping off of bus structures with the same size bus.The tap rule is designed to prevent overloads and ensure proper coordination of protective devices in electrical systems. It limits the number of taps that can be made from a single bus and the size of the taps relative to the size of the bus.In your example, you have a 400A bus and you are tapping off of it with 400A buses. This means that the taps are the same size as the bus, which violates the tap rule.The tap rule typically states that the total capacity of all taps from a bus cannot exceed 80% of the capacity of the bus. In your case, the total capacity of the taps is 400A + 400A = 800A, which is greater than 80% of the capacity of the 400A bus.Therefore, even though you are using the same size buses for the taps, you are still violating the tap rule and you need to be concerned about the potential for overloads and improper coordination of protective devices.The tap rule does come into play when tapping busses with cables or buses of a lesser size than the original bus. However, it also applies when tapping busses with the same size bus. Flag for review

Previous Question Next Question