Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Sequence network interconnection of 3-phase fault to ground with unequal impedance

User: royalflush

Asked on: Wednesday, February 2, 2011 at 9:07 pm EST
Answered on: Tuesday, May 14, 2024 at 1:05 am EDT

Question: Hi,Anybody has any idea how the sequence networks of a 3-phase fault to ground with unequal impedance should look like? How are they different than the balanced 3-phase fault?thanks

Sequence Networks for Unbalanced 3-Phase Fault to Ground

In an unbalanced 3-phase fault to ground, the impedance to ground is different for each phase. This results in different fault currents in each phase, and therefore, different sequence components.The symmetrical components method is used to analyze unbalanced fault conditions. In this method, the unbalanced system is decomposed into three balanced symmetrical components: Positive-sequence component (a) Negative-sequence component (b) Zero-sequence component (c)Sequence Impedances

The positive-sequence impedance (Z1) represents the impedance offered by the system to positive-sequence currents. The negative-sequence impedance (Z2) represents the impedance offered to negative-sequence currents. The zero-sequence impedance (Z0) represents the impedance offered to zero-sequence currents.

Sequence Networks

The sequence networks for an unbalanced 3-phase fault to ground are as follows:
Positive-sequence network

This network consists of the positive-sequence voltage source (E1) and the positive-sequence impedance (Z1) connected in series.

Negative-sequence network

This network consists of the negative-sequence voltage source (E2) and the negative-sequence impedance (Z2) connected in series.


Zero-sequence network

This network consists of the zero-sequence voltage source (E0) and the zero-sequence impedance (Z0) connected in series.

Differences from Balanced 3-Phase Fault


In a balanced 3-phase fault, the impedance to ground is the same for all three phases. This results in equal fault currents in each phase, and therefore, identical sequence components.In an unbalanced 3-phase fault, the impedance to ground is different for each phase. This results in different fault currents in each phase and different sequence components. As a consequence, the sequence networks for an unbalanced fault will be different from those for a balanced fault.

Applications

The sequence networks for unbalanced 3-phase faults to ground are used in various applications, including: Fault analysis Relay coordination System protection Generator protection Flag for review

Previous Question Next Question