Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: High current & warm wires

User: mike33, Location: Irvine, CA

Asked on: Thursday, February 3, 2011 at 1:25 am EST
Answered on: Tuesday, May 14, 2024 at 1:06 am EDT

Question: We just finished installing 26 High Bay Fluorescent fixtures in a warehouse. We knew we wouldn't be back for a couple days so we stayed a little late to make up all connections, land wires to breakers and install some temporary switches to see them light up. Everything looked great.I decided to check Amps before replacing cover and found one 20A circuit was drawing 19.5 Amps. This circuit has 8 lights on it, one of which I measured with an extension cord at 2 Amps on a different day.The wires in the junction box were noticeably warm to the touch.Could both of these problems be caused in a loose connection somewhere?Voltage drop?I had no more time to troubleshoot. I will be going back soon.

Loose Connection

A loose connection can increase resistance, causing heat buildup and increased current draw. This could explain the warm wires and high amps on the 20A circuit.

Voltage Drop

If there is significant voltage drop between the power source and the fixtures, the lamps may not receive sufficient voltage to operate properly. This can lead to reduced light output, shortened lamp life, and higher current draw.

Possible Causes



Loose connections

Inspect all electrical connections in the junction box and breaker panel for tightness.


Incorrect wire gauge

Ensure that the wire gauge used is appropriate for the current draw of the fixtures.

Overloaded circuit

The circuit may be overloaded with more lights or other loads than it can handle.


Voltage drop

Check voltage at the fixtures and verify that it is within the recommended range for the lamps.*

Damaged insulation

Examine the wires for any signs of damage or nicked insulation, which can cause a short circuit.

Troubleshooting Steps

1.

Safety First

Turn off power at the breaker panel.2.

Inspect Connections

Check all connections in the junction box and breaker panel for tightness.3.

Check Voltage

Measure voltage at the fixtures and verify it is within the recommended range.4.

Test Fixtures

If possible, remove one fixture from the circuit and test it separately to isolate any issues.5.

Check Wire Gauge

Verify that the wire gauge used is appropriate for the current draw of the fixtures.6.

Overload Check

Determine if the circuit is overloaded by calculating the total current draw of all fixtures and loads on the circuit.7.

Inspect Insulation

Examine the wires for any signs of damage or nicked insulation.

Note:
It is important to have the electrical system inspected by a qualified electrician to ensure safety and proper operation. Flag for review

Previous Question Next Question