Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Installation of Lighting Arresters on Metal roofs

User: tdcgam, Location: Huntsville Alabama

Asked on: Thursday, February 3, 2011 at 9:00 pm EST
Answered on: Tuesday, May 14, 2024 at 1:08 am EDT

Question: How should lighting arresters be installed on metal roofs?

Installation of Lighting Arresters on Metal RoofsMaterials

Lightning arrester(s) rated for the roof type and area Grounding rods Grounding wire (minimum 10 AWG copper) Conduit or raceway for wiring Sealant or flashing for weatherproofing Electrical tape Crimp connectors

Steps

1.

Choose Mounting Location

- Select a location on the roof with the least obstruction from surrounding objects.- Ensure it has a clear path to ground.2.

Install Grounding System

- Drive the grounding rods at least 10 feet (3 meters) deep into the ground.- Connect the grounding wire to the grounding rods and extend it back to the building.3.

Mount the Lightning Arrester

- Use stainless steel or aluminum mounting brackets to attach the lightning arrester to the roof.- Seal around the mounting base with sealant or flashing to prevent water infiltration.4.

Wire the Lightning Arrester

- Run the grounding wire from the arrester to the grounding system.- Use crimp connectors to secure the connections and wrap with electrical tape.- Route the wiring in conduit or raceway to protect it from the elements.5.

Connect to Building Ground

- Connect the grounding wire from the lightning arrester to the building's grounding system, such as the electrical service panel or a designated ground rod.6.

Weatherproof the Connections

- Apply sealant or caulk around all electrical connections to prevent moisture intrusion.- Ensure conduit or raceway is properly sealed at entry and exit points.7.

Final Inspection

- Visually inspect all connections and grounding to ensure proper installation.- Test the lightning arrester according to the manufacturer's instructions.

Additional Tips



Multiple Arresters

For large roofs or areas with significant exposure, multiple lightning arresters may be required.

Spacing

Arresters should be spaced evenly around the perimeter of the roof at a maximum distance of 60 feet (18 meters) apart.


Roof Pitch

Arresters should be installed vertically, regardless of the roof pitch.*

Avoid Sharp Objects:
Keep electrical wiring away from roof edges, vents, and other sharp objects that could damage the insulation. Flag for review

Previous Question Next Question