Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: al brach ckts

User: jeff schechter, Location: Shelby Twp. MI, near Detroit

Asked on: Friday, February 4, 2011 at 9:20 am EST
Answered on: Tuesday, May 14, 2024 at 1:09 am EDT

Question: how do i pigtail al ckts to cu only outlets?

Materials

Electrical junction box Pigtail wire connectors Electrical tape Wire strippers

Instructions

1.

Turn off power

Turn off the circuit breaker or fuse associated with the outlets you will be working on.2.

Remove old outlets

Remove the faceplates and screws holding the old outlets in place. Pull the outlets out of the junction box.3.

Cut pigtail wires

Cut 6 inches of 12/2 Romex wire for each outlet you need to pigtail. Strip about 1.5 inches of insulation from the black and white wires on each pigtail.
4.


Strip outlet wires

Strip about 1.5 inches of insulation from the black, white, and bare copper ground wires on each outlet.
5.


Connect black wires

Twist the black wire from the pigtail with the black wire from the outlet. Secure them with a pigtail wire connector.6.

Connect white wires

Twist the white wire from the pigtail with the white wire from the outlet. Secure them with a pigtail wire connector.7.

Connect ground wires

Connect the bare copper ground wire from the pigtail with the bare copper ground wire from the outlet. Use a pigtail wire connector or wrap the wires together and secure them with electrical tape.8.

Cap unused wires

If you have any unused wires in the junction box, such as a red wire, cap them off with a wire nut to prevent them from contacting other wires.9.

Push wires into junction box

Push all the connected wires into the junction box, leaving about 6 inches of slack for future adjustments.10.

Install new outlets

Insert the pigtailed outlets into the junction box and secure them with screws. Install the faceplates.11.

Test outlets

Turn on the power and test the outlets to ensure they are working properly.

Tips:
Use the correct gauge of pigtail wire for the circuit. Make sure all connections are tight and secure. Wrap wire connectors with electrical tape for added insulation. If you are connecting more than two outlets to a single pigtail, use a larger wire connector.* Always follow local electrical codes and consult an electrician if you are unsure about any aspect of the work. Flag for review

Previous Question Next Question