Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Nec article 610.53(a) taps to control transformer calculation questions

User: javiersalas52d, Location: Illinois

Asked on: Friday, February 4, 2011 at 11:59 am EST
Answered on: Tuesday, May 14, 2024 at 1:09 am EDT

Question: I have a question regarding taps to control transformer calculations, NEC ARTICLE 610.53(A) TAPS TO CONTROL TRANSFORMER1. I have a 100 VA 460/120 motor control transformer.2. The rated secondary current is 100/120 = 0.83.3. As I read the article rated secondary current 0.83 x 200% , 0.83 X 2 = 1.67. 1.67 should be my max size of secondary protective device.4. The last part of the article is where I believe I am confused, not more than 200% of the ampacity of the control circut conductors. As I read it, if the control circuit ampacity is 10 then multiply it by 200% and 10 x 2 = 20. The maximum amperage of the tap conductors can be no larger than 20? Any help you may provide will be be greatly appreciated.Javier

  1. Rated secondary current

    0.83 A (100 VA / 120 V)2.

    Maximum size of secondary protective device

    0.83 A x 200% = 1.67 A3.

    Maximum amperage of the tap conductors

    200% of the ampacity of the control circuit conductors

    Assumptions

    The control circuit ampacity is not specified in the question. It is assumed to be 10 A.

    Calculations

    10 A x 200% = 20 A

    Conclusion:


    Based on the assumptions, the maximum amperage of the tap conductors is 20 A. However, note that the actual ampacity of the tap conductors may be lower if the control circuit ampacity is lower. Additionally, the ampacity of the tap conductors should also be checked against the transformer manufacturer's recommendations.
Flag for review

Previous Question Next Question