Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: 2000A Main Tripped

User: SpiderMT, Location: Tennessee

Asked on: Friday, February 4, 2011 at 7:33 pm EST
Answered on: Tuesday, May 14, 2024 at 1:10 am EDT

Question: Had a service call today to check out a breaker that had tripped earlier in the week. Turns out it was the 2000A main w/ GFP. They had called the utility company and they told them to have an EC come out to look at the bussing and check for bad connections there.I wasn't able to open all sections and look at all the bussing but what i saw all looked good. I also have an IR camera and there is no excessive heat anywhere i could see so I don't think that overcurrent from loose connections was the problem.They did have a new piece of equipment installed the week before and the only thing I could think was that maybe there was a small ground fault in the motor and that tripped the Main because of the ground fault protection. This is the first time this has occured as far as anyone there could remember and it was 3 days ago so it is kind of hard to backtrack and they haven't had any problem since.I'm just wondering if anyone with more experience with these large GFP'd breakers tripping has any better ideas on things to look for.

Possible Causes of GFP Breaker Tripping



Ground fault

A very small fault (typically less than 5A) between a live conductor and ground. GFP breakers are designed to detect and trip on these faults to prevent shock and fire hazards.


Transient overvoltage

A sudden increase in voltage can cause the breaker to trip. This can occur due to lightning strikes, switching surges, or other electrical disturbances.

Damaged wiring or connections

Loose or damaged connections can create high-resistance paths that increase heating and cause the breaker to trip.


Overcurrent

While the main breaker is unlikely to trip due to overcurrent, a ground fault on a downstream circuit could still trip the main breaker if the fault current exceeds the GFP threshold.

Faulty equipment

A ground fault or other problem within the newly installed equipment could have caused the breaker to trip.

Troubleshooting Steps



Inspect all accessible bussing

Look for any loose connections, discoloration, or arcing marks.

Check for overcurrent conditions

Measure the load on the downstream circuits to ensure they are not exceeding the breaker's capacity.


Inspect the newly installed equipment

Check the wiring, connections, and motor terminals for any ground faults or other problems.

Perform a ground fault isolation test

This test can help identify the specific circuit or equipment causing the ground fault.


Check the GFP threshold setting

Ensure that the GFP threshold is set appropriately for the system's voltage and ground fault characteristics.

Monitor the system over time

Keep an eye on the breaker status and any changes in the load or ground fault current.

Additional Considerations:
GFP breakers have a time-delay feature that allows for brief ground faults to clear without tripping. If the fault persists or increases, the breaker will trip. GFP breakers are sensitive devices and can be influenced by the electrical characteristics of the connected system. Factors such as the system capacitance, inductance, and grounding practices can affect the breaker's behavior. Consult with the breaker manufacturer or a qualified electrician for specific guidance and troubleshooting procedures. Flag for review

Previous Question Next Question