Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: greenlee 555 sidewinder

User: gbilger, Location: Texas

Asked on: Friday, February 4, 2011 at 10:30 pm EST
Answered on: Tuesday, May 14, 2024 at 1:10 am EDT

Question: with an emt bender you can use the star for a back to back bend and not have to use the deduct method. How do you do that with the 555 if there is not enough conduit to travel throught the rollers for a back to back. I want to turn the pipe around and pull up on short end but still have my back to back turn out. No one I ask seems to be able to answer. there is no star on the sidewinder. Any help here. What do I add or subtract if I know where i want the back of my 90 is? Thanks.

Using the Greenlee 555 Sidewinder for Back-to-Back Bends Without a StarMaterials

Conduit Greenlee 555 Sidewinder

Steps

1.

Measure and Mark the Bend Points

Determine the desired back-to-back bend locations. Mark these points on the conduit.2.

Position the Conduit

Insert the conduit into the bender, aligning the first bend point with the designated slot on the bending shoe.3.

Bend the First 90 Degrees

Bend the conduit 90 degrees. This will create the first half of the back-to-back bend.4.

Calculate the Offset

To determine the offset needed for the second 90 degree bend, measure the distance between the first bend point and the marked location of the second bend point. Subtract the length of the first bend (90 degrees) from this measurement.5.

Adjust the Machine

Use the offset value to adjust the machine's angle setting. For example, if the offset is 3 inches, set the angle to 90 degrees - 3 inches = 87 degrees.6.

Turn the Conduit Around

Carefully remove the conduit from the bender. Turn it around, aligning the back of the first bend with the designated slot on the opposite side of the bending shoe.7.

Pull Up on the Short End

Hold the conduit firmly and pull up on the short end. This will create the second 90 degree bend.8.

Check the Bend

Verify that the back-to-back bends meet the desired specifications.

Tips:
Mark the conduits clearly to prevent errors. Use a bending lubricant to reduce friction. Be patient and adjust the machine settings slowly. Practice the technique on scrap conduit before attempting on actual installations. Flag for review

Previous Question Next Question