User: JefM, Location: Shelby Twp. MI, near Detroit
Asked on: Monday, February 7, 2011 at 7:56 am EST
Answered on: Tuesday, May 14, 2024 at 1:14 am EDT
Question: In our facility we are installing some new processes using reused equipment control panels that were manufactured in 1997 and relocated to Kentucky from a factory in California. These (robot) controller panels have a maintenance receptacle mounted in the control panel that is not GFCI protected. When we do our post-installation inspections and we write up these receptacles, the answer that we are given is that the equipment only has to meet the code of the date of manufacture. Does the NEC code make any provisions for relocated/refurbished/reused equipment being moved from state to state and not having to be ugraded ?
NEC Code Requirements
The National Electrical Code (NEC) requires that all electrical installations comply with the code in effect at the time of installation. This includes relocated equipment.
Exceptions
The NEC provides a few exceptions to this requirement, including:
Existing Installations
Existing installations that do not comply with the current code may continue to be used without alteration or repair if they are not hazardous.
Special Equipment
Equipment that was manufactured under different standards may be installed if it is approved by the electrical inspector and complies with specific NEC requirements.
GFCI Protection
The NEC requires GFCI protection for receptacles in wet or damp locations, including control panels. This requirement applies to all receptacles, regardless of the date of manufacture.
Relocated Equipment
When relocated equipment is installed, it must meet the requirements of the NEC in effect at the time of installation. This includes requirements for GFCI protection.
Conclusion:
Based on the provided information, the equipment you mentioned is not exempt from the requirement for GFCI protection. The NEC does not allow for exemptions based on the date of manufacture when relocating equipment. Therefore, the maintenance receptacle in the control panel should be upgraded to provide GFCI protection. Flag for review