Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: Suitability of IEC style fuses for supplementary motor branch protection.

User: Ugly, Location: Illinois

Asked on: Monday, February 7, 2011 at 3:42 pm EST
Answered on: Tuesday, May 14, 2024 at 1:16 am EDT

Question: Didn't see this exact thing discussed in search results I found.Considering similar to Littlefuse 477 series, a "5X20mm, time lag, ceramic body, 500VAC" at various ampacities. I can't see anything specific in the NEC preventing their use in this app as long as appropriate current rating per 430.52 is applied. Anybody have an opinion otherwise?The application in this case is a couple chain hoist motors subcircuit which is on a stepped down (400VAC) 5 wire branch circuit, and we would like to run smaller gauge copper out to the hoists.Howdy, I'm new. Nice place here.

Use of Littlefuse 477 Series Fuses in 430.52 Applications

The NEC does not specifically prohibit the use of Littlefuse 477 series fuses in 430.52 applications. However, it is important to consider the following factors: Voltage Rating

The 477 series fuses are rated for 500VAC. Ensure that the voltage on the circuit does not exceed this rating.


Ampacity

As you mentioned, the appropriate current rating must be selected according to NEC 430.52.

Time-Lag Characteristic

The 477 series fuses are time-lag fuses. This means they will tolerate short-term overloads before opening. Consider the starting current of the hoist motors and whether the fuse will provide adequate protection.


Approvals

Check if the 477 series fuses are approved by a recognized testing laboratory for use in industrial machinery applications.

Other Considerations for Stepped-Down 400VAC Circuit



Conductors

The reduced voltage will affect the ampacity of the conductors. Ensure the wire gauge selected for the hoist motors is appropriate for the amperage and voltage on the circuit.


Grounding

A properly grounded system is crucial for safety in industrial machinery applications. Verify that the grounding system meets NEC requirements.

Recommendation:


While the NEC does not strictly prohibit the use of Littlefuse 477 series fuses in 430.52 applications, it is advisable to consult with an experienced electrical engineer or electrician to assess the specific conditions of your installation. They can evaluate the factors mentioned above and provide guidance on the most appropriate overcurrent protection solution. Flag for review

Previous Question Next Question