User: X-27, Location: Lockport, IL
Asked on: Monday, February 7, 2011 at 6:58 pm EST
Answered on: Tuesday, May 14, 2024 at 1:16 am EDT
Question: My question concerns the second floor of a house that has three 'secondary bedrooms' (not a master bedroom). Each of these bedrooms has its own bathroom.We intend to run a dedicated 20A circuit to each bathroom just for it's receptacle(s) (no lighting). (I guess that's about as good as that can be done.)This house has mostly LED lighting, so the lighting loads are low. We were thinking that we could combine the lighting circuit for a bedroom with the lighting circuit for its respective bathroom. This Bedroom / Bathroom Lighting circuit would have NO outlets.I know that with heat lamps and other loads the "lighting load" in a smaller bathroom is not always small. However, the LED lighting for the adjacent bedroom will be less than 1 Amp.Thanks for reading.
Yes, you can combine the lighting circuits for the bedroom and its respective bathroom, provided that: The lighting loads of the bedroom and bathroom combined do not exceed the circuit's amperage rating. In this case, the circuit is 20A, so the combined lighting load should be less than 20A. The circuit is protected by a ground fault circuit interrupter (GFCI). This is required for all bathroom circuits, and it will protect against electrical shocks if there is a fault in the wiring.To calculate the combined lighting load, add up the wattage of all the lights in the bedroom and bathroom. Then, divide the total wattage by the voltage (usually 120V in the US) to get the total amperage.For example, if the bedroom lighting is 200W and the bathroom lighting is 100W, the combined lighting load would be 300W. Dividing by 120V gives 2.5A, which is well below the circuit's 20A rating.
Here is how you would wire the circuit
Run a new 20A circuit from the electrical panel to a junction box in the bedroom or bathroom. Install a GFCI outlet in the junction box. Connect the lighting fixtures in the bedroom and bathroom to the GFCI outlet. Do not connect any receptacles to this circuit.
Note: If you are not comfortable working with electrical wiring, it is best to hire a qualified electrician to do the work. Flag for review