Mike Dolt Enterprises Logo Mike Dolt Enterprises

Topic: solar backfeed thru transformer

User: rivrjay, Location: Wisconsin

Asked on: Tuesday, February 8, 2011 at 11:16 pm EST
Answered on: Tuesday, May 14, 2024 at 1:20 am EDT

Question: My question is about backfeeding a transformer. This is a 480 delta grounded system. The transformer will be a 480 delta too a 480/277 Y 4 wire. I havent ran across this situation yet. I just don't understand how this can backfeed without blowing anything up! please help me understand.The engineer said it will be fine but wont explain. Talked to another engineer and he said he wouldn't be caught even near it. Seeing that I am the one turning it on I just want to be sure. Any input or insight would be helpful.Thanks

Backfeeding a Transformer

Backfeeding a transformer occurs when power flows through the transformer in the opposite direction from its intended design. In your case, the power from the 480/277 Y 4-wire system would flow back into the 480 delta system.

How it Works

In a 480 delta system, the three phases have 480 volts between any two phases. In a 480/277 Y 4-wire system, the three phases have 277 volts between any two phases and 480 volts between any phase and the neutral conductor.When the transformer is backfed, the 480 volts from the 480/277 Y system are impressed on the 480 delta system. However, because the delta system has a lower impedance than the Y system, it draws more current. This increased current causes the voltage on the delta system to drop.As long as the delta system voltage remains below 480 volts, the overcurrent protection devices (such as fuses or circuit breakers) will not trip. This is why the transformer can backfeed without blowing anything up.

Safety Concerns

However, backfeeding a transformer does pose some safety concerns: Overheating

The increased current in the delta system can cause the transformer to overheat, potentially leading to failure.


Voltage Instability

The voltage drop on the delta system can affect other equipment connected to it, causing malfunctions or damage.

Shock Hazard

If the voltage on the delta system drops significantly, it can create a shock hazard for personnel working on the system.

Mitigation Measures


To mitigate these risks, the following measures can be taken:
Use a transformer with a higher kVA rating

A larger transformer can handle the increased current without overheating.

Provide adequate ventilation

Ensure that the transformer is properly ventilated to dissipate heat.


Monitor the voltage

Continuously monitor the voltage on the delta system to ensure that it remains above a safe level.*

Install overcurrent protection

Overcurrent protection devices should be installed on both the delta and Y systems to prevent damage in the event of excessive current flow.

Engineer's Opinion


The engineer who said it will be fine may have considered the above mitigation measures and determined that the risks are acceptable. The engineer who said he wouldn't be caught near it may have been overly cautious or may have experience with backfeeding transformers that have caused problems.Ultimately, the decision of whether to backfeed a transformer is a complex one that should be made by qualified engineers based on a thorough risk assessment. Flag for review

Previous Question Next Question